6
If required, the CTS terminal of the interface can be connected to the DTR output of the pager if this is provided.
Using the MxPager program, the fault input can be configured as monitored (used) / non-monitored (unused)
and can be inverted to provide compatibility with Normally Open (Inverted) or Normally Closed fault relay output
contacts.
The diagram above shows the EOL arrangement for the monitoring of the relay output contacts. The diagram
shows the normally closed condition.
2 Configuration
The MxPager software is used to configure the operation of the unit.
The program uses the standard RS232 upload / download lead supplied with the PC-NET-003 PC CONFIG
software for connecting the PC to the Pager Interface.
The software is supplied on a CD. To install the software onto the PC, insert the CD and the program should
auto-run. Follow the on-screen prompts to install the software.
If the auto-run feature is disabled or does not run, select START, RUN and enter D:\setup.exe where D: is the
drive letter of your CD drive.
To run the program, select Start, All Programs, Advanced Electronics, MxPager.
The program will open up with a new (blank) configuration file. The screen is as follows:
Use the normal windows “New, Open and Save” functions to create / open a
file via
either the “File” menu or the buttons.
The tree view on the left shows the list of configurable options.
The active view on the right shows the parameters and functions that can be changed for the option selected.
Additional buttons are available and are context sensitive
and are
grouped into common functions as follows.
a) Add / Delete / Edit pager addresses
b) Connect to / Disconnect from / Upload to target pager interface.
