www.advancedco.com
4
1.2 General Installation Notes
WARNING:
Disconnect all sources of power (AC and
battery) before installing/removing circuit cards or
servicing the AV-RMIC All-Call Remote Microphone.
USE an anti-static wrist strap whenever
handling circuit cards.
STORE circuit cards in static
suppressive packaging.
ENVIRONMENT:
INSTALL the equipment in a clean,
dry environment.
The equipment meets the requirements for operation at
32°F - 120°F (0°C - 49°C) and relative humidity of 85%
RH. However, standby battery life is drastically reduced
at higher temperatures. The recommended room
temperature for installation is 60°F - 86°F (15°C - 27°C).
WIRING:
CHECK that the installation wire sizes are
adequate to deliver the required load current and
maintain compatibility with the specific device operating
voltages.
A secure dedicated ground connection is
required. Although no system is immune to
the effects of lightning strikes, a secure
ground connection will reduce susceptibility.
The use of overhead or outside aerial wiring is
not recommended.
1.3 FCC
1.3.1 Emissions
WARNING:
This equipment generates, uses, and can radiate radio frequency energy. If it is not installed in
accordance with the instructions in this manual, it may cause interference to radio communications.
This equipment has been tested and found to be in compliance with the limits for a Class A computing device
pursuant to Subpart B of Part 15 of FCC Rules, which is designed to provide reasonable protection against such
interference when operated in a commercial environment. Operation of this equipment in a residential area is likely
to cause interference in which case, the user will be required to correct the interference at their expense.
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE DEVICES
Must be
Grounded