5 |
P a g e
8.
INSTALL THE OUTER RAILS
For Recessed Mount Applications:
Place one outer rail directly under the edge of the canister and firmly along the side jamb of the
structure.
The face of the outer rail that is towards the back of the canister should be lined up with the
back of the canister and run plumb vertically to the floor/base of the structure.
The open side of the outer rail should be facing towards the interior of the opening.
Secure the outer rail to the side jamb using the appropriate fastener.
Repeat for 2
nd
outer rail.
For Surface Mount Applications:
Place one outer rail directly under the edge of the canister and firmly along the face of the side
jamb of the structure.
The outer edge of the outer rail should be exactly along the line drawn in Instruction 6 ii. (b).
The access holes for installing the fasteners should face outwards.
The open side of the outer rail should be facing towards the interior of the opening.
Secure the outer rail to the side jamb using the appropriate fastener.
Install the color-matched hole-caps in the access holes of the outer side rail.
Repeat for 2
nd
Outer rail.
9.
INSTALL THE SCREEN PANEL, TUBE, MOTOR ASSEMBLY
**** Depending on the size of the unit, 2 persons may be needed for this step of the installation ****
Orient the screen tube assembly such that:
a.
The motor end of the assembly is at the end of the canister with the 5/8” hole and at the end of
the canister with the U-bracket.
b.
The spring idler end of the assembly is on the end of the canister with the starred bracket;
c.
The bottom zipper is falling off the back of the screen motor tube assembly;
d.
Turn tube so as to unroll the entire screen panel until you see the top zipper on the roll-tube;
e.
The two limit adjustment switches on the end of the motor must be accessible from the front.
Place the spring idler end of the screen tube assembly in the bracket with the starred hole.
Pass the electrical cord through the 5/8” hole made for that purpose in Instruction 7 above. Loop and tie
the electrical cord with the loop below the motor, such that any water running along the cord will not
reach the head of the motor.
Place the square metal idler of the motor end of the screen tube assembly in the U-bracket and secure
the motor end to the U-bracket using the Cotter pin. Use the holes closest to the bottom of the U-
bracket.
Install the electrical plug to the end of the power cord and plug it in; OR Connect the power cord to the
circuit
With the screen panel hanging off the back of the metal roll-tube assembly and then continuing down
along the front of the two outer side rails, move the top zipper, secured on to the metal roll-tube, to the
left or right such that the side zippers of the screen panel line up with the lines down the center of the
outer side rails
