A.
THE MOTOR AND SIX CHANNEL REMOTE COMES FROM THE FACTORY WITH CHANNEL ONE
SYNCHRONIZED.
B.
TEMPORARY UPPER AND LOWER LIMITS HAVE BEEN SET AT THE FACTORY. THE SCREEN PANEL IS
ROLLED UP ON THE TUBE SO THAT WHEN YOU POSITION IT CORRECTLY IN THE HOOD WITH THE
LIMIT ADJUSTMENT SWITCHES FACING FORWARD THE SCREEN PANEL WILL BE AT ITS UPPER
LIMIT. YOU WILL NEED TO ADJUST THE LOWER LIMIT TO ITS PERMANENT POSITION. YOU WILL
ALSO NEED TO FINE TUNE THE UPPER LIMIT.
C.
THERE WILL BE NO NEED TO CHANGE ANY OTHER PROGRAMMING IN THE REMOTE UNLESS
SIGNIFICANT CHANGES ARE MADE TO THE UNIT, SUCH AS CUTTING THE VERTICAL SIDE RAILS.
D.
HOW TO: SWITCH THE MOTOR BETWEEN CONTINUOUS AND MANUAL MODE
Prior to adjusting any of the factory settings of the motor and remote, be sure to place the
motor in manual mode.
In manual mode, when you press & release the UP or DOWN buttons the screen moves
approximately 3” and stops. In manual mode, if you press & hold the UP or DOWN button for 3
seconds then the screen will run continuously.
Being in manual mode will reduce the chance of damage occurring to the unit while settings are
being changed. To do this:
1.
PRESS & HOLD the STOP BUTTON until the motor jogs up and down or sounds 5
beeps
2.
Within the 5 beeps, release the STOP BUTTON, THEN PRESS & RELEASE the STOP
BUTTON. The motor will jog up and down or sound 3 beeps
To take the motor out of manual mode and back into continuous mode repeat steps 1 & 2
above.
E.
HOW TO: REVERSE THE DIRECTION OF THE MOTOR
Should the motor be in a state where the UP button on the remote lowers the screen panel and
the DOWN button raises the screen panel, you will need to reverse the direction of the motor.
To do this:
1.
PRESS & HOLD the STOP BUTTON until the motor jogs up and down or sounds 5
short beeps.
2.
Within the 5 beeps, PRESS & RELEASE the DOWN BUTTON. The motor will jog
up and down or sound 3 short beeps.
