Advanced Lighting Systems ALS-LLED-100, Руководство по установке

Страница: 9 / 10

9
A
dvAnced
L
ighting
S
yStemS
,
LLc
• 519 L
incoLn
R
oAd
• S
Auk
c
entRe
, m
inneSotA
56378 •
t
320 352 0088 •
f
320 352 0089 •
AdvAncedLighting
.
com
•
nASdAq
:
nexS
Symptom: Probable Cause: Suggested Remedy:
Unit does not light No power to unit Check power supply & cord
Line voltage is <90 VAC Use @ rated voltage
Power supply failure Contact Authorized Distributor
Driver failure Contact Authorized Distributor
One color won’t light Damaged driver Contact Authorized Distributor
LED board short Contact Authorized Distributor
Low performance Dirty Lens Clean lens w/ soft dry cloth
Damaged lens Contact Authorized Distributor
Damaged sub-optic board Contact Authorized Distributor
No DMX response Bad cable connection Check cables
DMX driver malfunction Contact Authorized Distributor
Address issues Check for proper DMX address
9.0 Maintenance of Luminaire
8.0 Troubleshooting
Prior to any maintenance or service of the unit, always disconnect power cord and allow unit to
cool for at least five (5) minutes.
Periodic Cleaning:
Clean the LiveLED at least once every 6 months. Dust exterior with a soft cloth. Make certain that
lenses are free of obstructions and debris.
Fuse Replacement
In the event that the fuses need to be replaced, use only 250 volt 5 amp AC type of fuse. Turn the
power OFF; remove the power cord from the power outlet. Locate the fuse holder on the rear of
the fixture. Remove and replace the fuses if needed. Plug in the power cord and the unit is ready
for continued operation.
©2008 Nexxus Lighting, Inc.
For additional assistance or questions contact an authorized distributor or dealer for
Advanced Lighting Systems, Inc. or contact the factory at:
Advanced Lighting Systems, Inc.
519 Lincoln Road
Sauk Centre, MN 56378
Tel: 320.352.0088
Fax: 320.352.0089