4
A
dvAnced
L
ighting
S
yStemS
,
LLc
•
519 L
incoLn
R
oAd
•
S
Auk
c
entRe
, m
inneSotA
56378
•
t
320 352 0088
•
f
320 352 0089
•
AdvAncedLighting
.
com
•
nASdAq
:
nexS
3.0 General Operating Instructions
Top knob is 3rd digit
Middle knob is 2nd digit
Bottom knob is 1st digit
Green
Red
DMX Rotary Control
Knobs correspond to
DMX code as follows:
CONTROL PANEL
Red LED light indicates DMX system has power.
Green indicates DMX system has signal.
Flashing Green indicates DMX operation is being executed
STAND ALONE OPERATION
To operate the LiveLED 100 as a stand alone unit, rotate the knobs on the Control Panel to activate
the preset program desired (see preset program table below).
MASTER/SLAVE OPERATION
The master / slave control allows multiple units to operate in synchronization without an external con-
troller. Using 3 pin XLR cables, link the units together to the XLR cables on the rear of each LiveLED.
Either connector may be used as either the in or out. Choose a unit to be the Master. Set the rotary
knobs of the Master to the desired preset program (see preset program table below). Set all other
Slave units to 001. Be sure none of the units are connected to any other controller or DMX system.
When the system power is turned on, all Slave units will follow the Master. Check the green indicator
light on the control panel of the Slave units to insure that units are receiving a DMX signal from the
Master unit.
Note: The rotary knob next to the red indicator light is the first digit for the preset programs (see
control panel picture).
x1
x10
x100
