Advanced Card ACR100I, Справочное руководство

Страница: 13 / 20

ACR100I – Reference Manual
info@acs.com.hk
Version 1.00
www.acs.com.hk
Page 13 of 20
Offset Field Size Value Description
6 BSeq 1 Sequence number for command
7 AbRFU 3 Reserved for future use
The response to this message is the RDR_to_PC_Parameters message.
7.1.1.7. PC_to_RDR_SetParameters
Set slot parameters.
Offset Field Size Value Description
0 bMessageType 1 61h
1 dwLength 4 Size of extra bytes of this message
5 bSlot 1
Identifies the slot number for this
command
6
bSeq
1 Sequence number for command
7 bProtocolNum 1
Specifies what protocol data structure
it follows.
00h = Structure for protocol T=0
01h = Structure for protocol T=1
The following values are reserved for
future use.
80h = Structure for 2-wire protocol
81h = Structure for 3-wire protocol
82h = Structure for I2C protocol
8 abRFU 2 Reserved for future use
10
abProtocolDataStructure
Byte
array
Protocol Data Structure
Protocol Data Structure for Protocol T=0 ( dwLength=00000005h )
Offset Field Size Value Description
10 bmFindexDindex 1
B7-4 – FI – Index into the Table 7 in
ISO/IEC 7816-3:1997 selecting a clock
rate conversion factor.
B3-0 – DI – Index into the Table 8 in
ISO/IEC 7816-3:1997 selecting a baud
rate conversion factor.
11 bmTCCKST0 1
B0 – 0b, B7-2 – 000000b
B1 – Convention used (b1=0 for direct,
b1=1 for inverse)
Note: The CCID ignores this bit.
12 bGuardTimeT0 1
Extra Guardtime between two characters.
Add 0 to 254 etu to the normal guardtime
of 12 etu. FFh is the same as 00h.
13 bWaitingIntegerT0 1 WI for T=0 used to define WWT