Advance acoustic Warrior AXP, Руководство по обслуживанию, Страница: 82 / 86

80 - FORM NO. 56043103 - Warrior ™ ST, Warrior™ AXP
APPENDIX
DETERGENT (AXP™) SYSTEM PREPARATION AND USE
REFILLABLE CARTRIDGE SPECIFIC INSTRUCTIONS:
Fill the detergent cartridge with a maximum of 1.25 gallons (4.73 Liters) of detergent.
SERVICE NOTE: Remove the detergent cartridge from the detergent box prior to fi lling to
avoid spilling detergent on the machine.
It is recommended that a separate cartridge be used for each detergent you plan to use.
The detergent cartridges have a white decal on them so you can write the detergent name
on each cartridge to avoid mixing them up. The detergent cartridge has a Magnetic Slider
(CC) on one end that needs to be set to the proper dilution ratio according to the dilution
instructions on the manufacturer’s bottle. Slide the Magnet Slider (CC) to the appropriate
location on Detergent Dilution Ratio Decal (DD) . When installing a new cartridge, remove
the Cap (AA) and place the cartridge in the detergent box. Install the Dry Break Cap (BB)
as shown.
SERVICE NOTE: Refer to MAIN CONTROL PROGRAMMING OPTIONS, Chemical User
Ratio Selection to electronically program the chemical ratio if your cartridge has no magnetic
slider.
COMMON INSTRUCTIONS:
The system should be purged of previous detergent when switching to a different detergent.
SERVICE NOTE: Move machine over fl oor drain before purging because a small amount
of detergent will be dispensed in the process.
To Purge When Changing Detergents:
1 Disconnect and remove the detergent cartridge.
2 Turn the Key Switch (A) ON and press the Detergent Switch (F) and the Solution
Switch (B) down for at least 3 seconds. NOTE: Once activated the purge process
takes 10 seconds. See illustration on next page for Detergent System indicators.
Normally one purge cycle is adequate to purge the system.
To Purge Weekly:
1 Disconnect and remove the detergent cartridge. Install and connect a Cartridge fi lled
with clean water
2 Turn the Key Switch (A) ON and press the Detergent Switch (F) and the Solution
Switch (B) down for at least 3 seconds. NOTE: Once activated the purge process
takes 10 seconds. See illustration on next page for Detergent System indicators.
Normally one purge cycle is adequate to purge the system.
When the Detergent Cartridge is almost empty a Display Panel (D) indicator will come
on. This “Low Detergent” indicator will remain on until you reset the system. Once this
indicator comes on you should be able to simply pour an entire gallon bottle of detergent
into the Cartridge to re
fi ll without worrying about measuring. NOTE: Only reset the system
when the cartridge is full. When switching cartridges, the “Low Detergent” indicator is
only accurate if the replacement cartridge is at the same level as the cartridge being
replaced.
To Reset:
1 Turn the Key Switch (A) ON and hold the Detergent Switch (F) down for 3 seconds.
See the illustration to the right for Detergent System indicators.
NON-REFILLABLE CARTRIDGE SPECIFIC INSTRUCTIONS:
Remove the Cap (AA) and place the cartridge in the detergent box. Install the Dry Break
Cap (BB) as shown.
revised 5/08