Advance acoustic Terra 5200 B, Руководство по обслуживанию

Страница: 41 / 112

DUST AND DEBRIS COLLECTION SYSTEM
SERVICE MANUAL ENGLISH
Terra™ 5200 1463546000(1)2008-07 39
DUST AND DEBRIS COLLECTION SYSTEM
PANEL DUST FILTER CLEANING AND INTEGRITY CHECK
NOTE
Besides the standard paper filter, polyester filters are also available. The following procedure is applicable to each type of
filter.
Drive the machine on a level floor and engage the parking brake with the pedal and the lever (25 and 18). 1.
Turn the ignition switch (17) to “0”. 2.
Open the hood (49) and fasten it with the support rod (63). 3.
Disconnect the battery connector (52); keep the hood open. 4.
Disconnect the vacuum system motor connector (57). 5.
Release the fasteners (A) and remove the vacuum system motor cover (B). 6.
Disconnect the electrical connector (C) from the filter shaker. 7.
Remove the filter shaker support frame fastening handwheels (D). 8.
Remove the filter shaker support frame (E). 9.
Remove the dust filter (F). 10.
In an outdoor area, clean the filter by shaking it on a level and clean surface, tapping the side (G), opposite to the wire gauze 11.
(H). Complete the cleaning procedure by using compressed air (I) at maximum 6 Bar, blowing only from the side protected by
the wire gauze (H), at a minimum distance of 11.8 in (30 cm).
According to the filter type, observe the following cautions:
Paper filter (standard): do not use water or detergents to clean it; the filter can be damaged; •
Polyester filter (optional): To clean it, see the above-mentioned instructions. If necessary, for a better cleaning, it is allowed •
to wash the filter with water and non-lathering detergents. This provides better quality cleaning but reduces the life of the
filter, which will have to be replaced more frequently. The use of inadequate detergents can damage the filter.
Check the filter body for tears.
Clean the filter compartment rubber gasket (L) along its perimeter and check it for integrity. If necessary, replace it. 12.
Assemble the components in the reverse order of disassembly. 13.
NOTE
When reinstalling the filter, the wire gauze (H) must be facing upward.