Advance acoustic SW5500, Инструкция по эксплуатации

Страница: 16 / 140

ENGLISH INSTRUCTIONS FOR USE
14
SW5500 - 1467284000 09/2016
USE
WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER
– WARNING
–
CAUTION
– CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates (see the Visible Symbols
On The Machine paragraph).
Do not cover these plates for any reason and immediately replace them if they are damaged.
If the machine has not been used after being transported, check that all the blocks have been removed.
BATTERY CHECK/SETTING ON A NEW MACHINE
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
or connected. The batteries must be installed by qualified personnel only.
According to the type of batteries (WET or GEL-AGM), set the electronic board of the machine.
Check the batteries for damage before installation.
Disconnect the battery connector.
Handle the batteries with great care.
Install the battery terminal protection caps supplied with the machine.
The machine requires one 24 V battery, or four 6 V batteries connected according to the diagram (44).
The machine can be supplied in one of the following configurations:
p) Batteries already installed and ready to be used
q) Without batteries
According to machine configuration, proceed as follows.
a) WET or GEL-AGM batteries already installed on the machine
1. Open the hood (19) and fasten it with the support rod (47).
2. Check that the batteries are connected to the machine with the connector (45).
3. Remove the support rod (47) and close the hood (19).
4. On first use of the machine with new batteries, perform a complete charging cycle of the batteries (see procedure in the
Maintenance chapter).
b) Without batteries
1. Buy appropriate batteries (see Technical Data paragraph). For battery choice and installation, apply to qualified battery
Retailers.
2. Depending on the type of battery chosen, set the machine as specified in the Operating Parameters paragraph in the
Maintenance chapter.
3. Perform a complete charging cycle of the batteries (see procedure in the Maintenance chapter).
BEFORE MACHINE START-UP
Checklist
1. Have a full knowledge of the machine operating controls and their functions.
2. Insert the key (51) and start the machine (see the procedure in the following paragraph).
3. In the first 2 seconds after turning on, the multifunction display (71) shows the machine working hours (71-A), the type of
batteries set (71-B) and the current maximum machine speed setting (71-C).
NOTE
Check the battery charge. When at least one non-flashing segment of the battery symbol on the multifunction
display (71-D) is lit, the machine is ready for use. When only one battery symbol segment remains and starts flashing
, it is advisable to recharge the batteries (see procedure in the Maintenance chapter).
4. Check correct operation of the horn with push-button (65), the reverse warning buzzer with push-button (64), and the working
light push-button (67, optional).
5. Check the parking brake (7 and 6). The brake must hold its (locked parked) setting firmly without easily being released (report
all defects immediately to Advance Service Center).
6. Check the service brake pedal (6) for proper operation.
WARNING!
If the pedal is “spongy” or fades under pressure without an efficient braking force, do not drive the machine
(report all defects immediately to Advance Service Center).
7. Make sure that there are no open doors/hoods and that the machine is in normal operating conditions.
1467284000(B)04-2018.indb 14 10/04/2018 12:19:45