FORM NO. 041410 / HYDRO-RETRIEVER 2067 -
11
PREPARING THE MACHINE FOR USE
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
BEFORE EACH USE
•
Inspect the machine for damage and oil or water leaks.
•
Check the engine oil level.
•
Check the fuel level.
•
Check to see that the hopper and the recovery tank are empty.
•
Squeeze the rubber dust cup on the engine air filter to release built-up dust.
•
Check the air filter service indicator.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
MAIN BROOM
Several different main brooms are available for this machine. Contact your advance dealer if you need help selecting the best broom for the surface
and litter that you will be sweeping. Note: Reference broom maintenance for installation steps.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
SCRUB BRUSHES
Raise the squeegee to allow access to the scrub brush area. Slide the scrub brushes under the four brush mounting plates and lift them so that the
lugs in the brushes pass through the holes in the plates. Turn the brushes until they lock in place.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
FILLING THE SOLUTION TANK
The solution tank fill
(A)
, located at the left rear corner of the machine, has a 95 gallon (360 liter) capacity. Fill the tank with the proper dilution of cleaning
Chemical mixed with water according to the manufacturer’s recommendations. If using a powdered chemical, mix it with water in a bucket before
putting it into the machine’s solution tank.
CAUTION !
Use only low-sudsing, non-flammable, non-caustic cleaning chemicals intended for machine application.
A
