Wall mount Installation Steps
To install the SDX810-RG, refer to
Figure 6
and
complete the following steps.
NOTE
Do not mount the SDX810-RG above three meters
from the floor.
Wall Mount Installation
To wall mount the SDX810-RG, complete the
following steps:
Refer to
Figure 6
when installing the SDX810-RG
on a wall.
1. Determine a location for the SDX810-RG.
Figure 6. Wall Mount Keyholes
2. Use the key holes on the back of the
SDX810-RG as a template and install two #6
drywall anchors.
3. Install two Ø 3.5*30L Pan Head screws. Leave
approximately 1/4-inch (0.6 cm) protruding from
the mounting surface. Refer to
Figure 7
.
F
Figure 7. Place Ø 3.5*30L Screws
4. Slide the SDX810-RG over the Pan Head
screws and exert a small amount of downward
pressure to ensure that the top of the slots are
resting on the shafts of the Pan Head screws.
