4
617101561PF2-13A
Connect AC Power
To connect the AC power cord to the switch, complete the following steps.
1. Connect the AC power cord to the AC power receptacle on the rear panel of the switch.
2. Connect the other end of the AC power cord to a properly grounded AC power outlet. The AC branch circuit socket-outlet must be installed near the equipment and must
be easily accessible.
3. Confirm that the power is connected properly. The
SYSTEM
LED should be ON (see
).
Figure 8. Connecting the AC Power Cord
g
NOTE
The installation of this product must comply with the national, state and local electrical code requirements, as applicable. The AC branch circuit overcurrent protection must be a
fuse or circuit breaker rated 125 VAC, 20 Amps maximum or 250 VAC, 16 Amps maximum. A readily accessible disconnect device that is suitably approved and rated must be
incorporated in the field wiring.
f
CAUTION!
It is recommended that an external AC Surge Protection Device be installed at the AC input connection to the local AC-Powered product. The Surge Protection device should
provide L-N, L-G, and N-G protection. It is also recommended that the device contains a visual 'GOOD' indicator.
f
WARNING!
This equipment incorporates double pole/neutral fusing. If the neutral fuse opens and the line fuse does not open, voltage could still be present in the unit.
Install SFP Modules
You can install or remove an SFP module from an SFP port without having to power off the switch. To install an SFP module, complete the following steps.
1. Insert the module into the appropriate SFP port.
2. Press firmly to ensure that the module seats properly into the connector.
Figure 9. Installing an SFP Module into an SFP Port
g
NOTE
This product is intended for use with a Class 1 Laser module that complies with FDA 21 CFR 1040.10, 1040.11 and IEC 60825-1. For continued compliance with the above
standards, only approved Class 1 Laser modules from an ADTRAN approved vendor list (located on the ADTRAN website) should be installed in this product. ADTRAN cannot
certify system integrity with other laser modules. The CDRH Laser Class emitted by the Fiber Optic Laser Module Component is Class I or 1 when installed in the end-product
with the fiber-optic cable removed.
