ADTRAN NetVanta 1000 Series, Руководство по установке оборудования

Страница: 36 / 48

Unit Installation NetVanta 1000 Series Switch Hardware Installation Guide
36 © 2004 ADTRAN, Inc. 61200500L1-34C
Wall Mounting the NetVanta
By following these instructions exactly, the NetVanta can be safely mounted to the wall.
Instructions for Wall Mounting the NetVanta
Step Action
1 Remove the mounting ears. Rotate them 90 degrees so that the portion of the bracket with the
mounting holes is flush with the bottom of the chassis. Reattach the mounting ears to the
chassis (see Figure 13 on page 37).
2 Decide on a location for the NetVanta. Keep in mind that the unit needs to be mounted at or
below eye-level so that the LEDs are viewable.
3 Prepare the mounting surface by attaching a board (typically plywood, 3/ 4" to 1" thick) to a wall
stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
4 Have someone else hold the unit in position as you install two #6 to #10 (1 1/ 2" or greater in
length) wood screws through the unit’s brackets and into the mounted board (see Figure 13 on
page 37).
5 Proceed to the steps given in Supplying Power to the Unit on page 37.
To avoid damaging the unit, use only the screws included in the shipment when attaching
mounting ears to the chassis.