ADTRAN Express 5210, Руководство пользователя

Страница: 87 / 203

Chapter 7. DTE Port Configuration
61200208L1-1 Express 5210 User Manual 7-11
LLC2 SSAP
Defines a point-to-point connection on the network. For an SDLC
connection, the SSAP of one Express 5210 should match the DSAP
on the other Express 5210. The value of this parameter must be in
hex and in increments of four beginning with 04.
LLC2 DSAP
Defines a point-to-point connection on the network. For an SDLC
connection, the DSAP of one Express 5210 should match the SSAP
of the other Express 5210. The value of this parameter must be in
hex and in increments of four beginning with 04. See the section
SNA/SDLC with Local Spoofing on page 5-1 for a configuration
example which demonstrates the SSAP and DSAP arrangement.
Outgoing DLCI (OUT DLCI)
Enter the DLCI address that identifies the virtual circuit used to
make the SDLC connection.
Transparent BOP Protocol (TRANS BOP)
T
RANSPARENT
BOP is a synchronous mode which can accept any
HDLC-like protocol as input. This setting allows the Express 5210
to connect to devices even if the Express 5210 does not understand
their protocol addressing and controlling techniques. The
Express 5210 becomes transparent to the data link layer protocol
and provides end-to-end connectivity between two HDLC-like
devices. See Figure 7-6 for the
T
RANSPARENT
BOP menu tree.
When building or editing an A
DDRESS
T
ABLE
, you must use the
Next
,
Prev
,
Add
, and
Delete
keys on the front panel (described in the chart on
page page 3-9), or the
Insert
and
Delete
functions of the terminal inter-
face (described in the chart on page 3-7).