ADTRAN 424 ONT, Быстрый запуск

Страница: 2 / 4

2 61287835F1-13A
To wall mount the 424 ONT, refer to Figure 1 and complete the
following steps:
1. Decide on a location for the 424 ONT. Mount below eye-
level so the LEDs are visible.
Figure 1. Wall Mount Installation
2. Use the keyholes on the rear of the 424 ONT as a template
and mark the wall accordingly.
3. Use a hammer to lightly tap the included wall anchors into
the marks until the threads are close to the wall. You can
also pre-drill holes using a 1/4” drill bit if difficulty is
encountered.
4. Insert either a #2 or #3 Phillips head screw driver into the
recess of the anchor head.
5. Using gentle forward pressure, rotate the wall anchor
counter-clockwise until the collar is flush with the wall.
6. Install four included screws into the anchor heads. Leave
approximately 1/4 inch (6 mm) protruding from the mounting
surface.
7. Slide the 424 ONT over the screws and exert a small
amount of downward pressure to ensure that the top of the
slots are resting on the shafts of the screws.
g
NOTE
Alternately, wall anchors are not needed if mounting directly to
wall studs.
Step 2: Connect Telephone
The 424 ONT has two telephone connections labeled PHONE1
and PHONE2 on the rear of the 424 ONT. To connect the primary
telephone line, simply plug the RJ-45 cable running from the
primary telephone unit into the
PHONE1 connection on the rear of
the 424 ONT. Any subsequent phones will be connected to the
PHONE2 jack.
Step 3: Connect Internet
The 424 ONT supports four 1 Gigabit (10/100/1000Base-T)
Internet connections labeled
GE1 through GE4 . To connect the
primary computer to the Internet, simply plug the Ethernet cable
Wall Anchor
Screw
Installation Guidelines
The following are guidelines for this installation.
■ Read all warnings and cautions before installing or servicing
the 424 ONT.
■ Do not locate the 424 ONT in direct sunlight or next to any
thermal devices.
Installation Overview
To install the 424 ONT, you will need to complete the following
steps:
■ “Step 1: Installing the 424 ONT”
■ “Step 2: Connect Telephone”
■ “Step 3: Connect Internet”
■ “Step 4: Clean Fiber Optics Cable Connections”
■ “Step 5: Connect Fiber Optics Cable”
■ “Step 6: Connect Power”
■ “Step 7: Connect UPS”
Required tools
Standard technician tools and those listed below are required for
installing the 424 ONT:
■ Carpenter’s level
■ Four #8 Pan Head screws (1 inch or greater in length)
■ #2 or #3 Phillips head screw driver
■ Drill
■ Hammer
■ A telephony/data communication test set
■ PON power meter with wavelength filtering
■ Fiberscope or videoscope
■ Assorted tie wraps for securing cabling and wiring
For fiber optic connections, the following are required:
■ Fiber optical fusion splice tools
■ ODC Fiber cleaning tool
■ SC Fiber connector
Step 1: Installing the 424 ONT
Installation consists of either placing the 424 ONT on a flat
surface, for example, a desk, or, mounting the ONT to a wall.
Desktop Placement
The 424 ONT can sit on a desktop or equivalent flat, stable
surface. Do not place the 424 ONT in direct sunlight or next to any
thermal obstructions.
Wall Mount Installation
g
NOTE
Refer to Figure 1 when installing the 424 ONT on a wall mount.