61287562G1-22A
3
Step 4: Connect Fiber
CAUTION
C
LASER RADIATION
1310 nm to 1600 nm
Do not view directly with optical instruments.
This product contains a Class 1M Laser module that complies with 21 CFR
1040.10 and 1040.11 and IEC 60825-1 and -2.
Fiber is installed using an SC connecter attached to the
OPTICAL
Interface on the rear of the Home Gateway ONT. Refer to the
illustration on the first page and complete the following steps to
connect fiber:
1. Remove the protective cover from the
OPTICAL
Interface.
NOTE
The protective cover should always be inserted in the optical
interface when the Fiber connection is not in use. This will help
protect the optical components.
2. Clean the ends of the SC connector and the surface of the
OPTICAL
Interface using appropriate fiber cleaning
methods.
3. Connect the incoming fiber cable to the SC connection.
4. Route the fiber cable so that it is protected from accidental
harm.
Step 5: Connect Power
To connect power to the Home Gateway ONT, refer to the illus-
tration on the first page and complete the following steps:
1. Plug the supplied 12V AC/DC Power Converter into the
PWR
connection on the rear of the Home Gateway ONT.
2. Connect the power plug to a standard 120V AC outlet.
3. Verify the power is on by checking the
PWR
LED on the
Home Gateway ONT. The LED should be green indicating
local power is on and voltage is good.
ON/OFF Button
An On/Off button is located on the far-right side of the rear of the
Home Gateway ONT. User functionality is limited to this button.
NOTE
If a Battery Backup (BBU) is being used and is disconnected, the
Home Gateway ONT is not protected from power outages, and
will send a “Battery Missing” alarm to the OLT.
Step 6: Connect USB
The Home Gateway ONT is equipped with a USB port. Refer to
the illustration on the first page for the location of this connection.
LED S
TATUS
The LEDs are located beneath the plastic housing and are only
visible after power has been applied. The following table provides
the LED status during normal operations.
*ONU. An Optical Network Unit (ONU) is a device that transforms incoming optical
signals into electronic signals at a customer’s premises.
Label
Status
Indication
PWR
Off
Green
ONT power is Off
ONT power On
LINK
2
Off
Green
Green Flashing
ONT is not active (not Ranged)
ONT is active (Ranged)
ONT is activating (Ranging in
progress)
AUTH
2
Off
Green
Green Flashing
ONU* is NOT authorized
ONU is authorized
ONU is registering
LAN1 -4
2
Off
Green
Green Flashing
Link is down
LAN Port is up
LAN Port is actively transmit-
ting and receiving
TEL1 - 2
2
Off
Green
Green Flashing
ONT is not registered
ONT is registered and on hook
Off hook or call in progress
INTER-
NET
2
Off
Green
Green Flashing
WAN not configured
Internet is connected
Internet is connecting
WPS
2
2
Off
Green
Yellow Flashing
Red Flashing
WPS is disabled
WPS status is “Successful”
WPS status is “in Progress”
WPS is experiencing errors
WLAN
2
Off
Green
Green Flashing
Error/WLAN is not connected
WLAN is connected
WLAN receiving/transmitting
data
USB
2
Off
Green
Green Flashing
No power or USP not con-
nected
USP connected
USP receiving/transmitting
data
DRAFT
