ADTRAN 3192 H4TU-C, Установка и эксплуатация

Страница: 3 / 30

61223404L2-5A Issue 1, December 2003 3
2. INSTALLATION
After unpacking the 3192 H4TU-C, inspect it for
damage. If damage has occurred, file a claim with the
carrier, then contact ADTRAN Customer Service.
Refer to the
Warranty and Customer Service section for
further information. If possible, keep the original
shipping container for returning the 3192 H4TU-C for
repair or for verification of shipping damage.
CAUTION
Electronic modules can be damaged by ESD.
When handling modules, wear an antistatic
discharge wrist strap to prevent damage to
electronic components. Place modules in
antistatic packing material when transporting
or storing. When working on modules, always
place them on an approved antistatic mat that is
electrically grounded.
Instructions for Installing the Module
To install the 3192 H4TU-C, perform the following
steps:
1. If present, remove the Access Module Blank from
the appropriate access module slot of the HDSL4
chassis.
2. Hold the 3192 H4TU-C by the front panel while
supporting the bottom edge of the module.
3. Align the module edges to fit in the lower and
upper guide grooves for the access module slot.
4. Slide the module into the access module slot.
Simultaneous thumb pressure at the top and at the
bottom of the module will ensure that the module is
firmly positioned against the backplane of the
chassis.
When the 3192 H4TU-C first powers up, it runs the
power up self-tests. Once the power up self-test is
complete, the status LEDs will reflect the true state of
the hardware.
Front Panel LEDs
LED indicators mounted on the front panel of the unit
provide the status of the HDSL circuit. See
Table 3 for
a listing of the front panel LEDs and their indications.
C A U T I O N !
SUBJECT TO ELECTROSTATIC DAMAGE
OR DECREASE IN RELIABILITY.
HANDLING PRECAUTIONS REQUIRED.
Table 3. Front Panel LED Indicators
Front Panel Label Condition Description
DSL 1
DSL 2
Green
Red
DSL Loop 1 and Loop 2 sync, no errors detected, and signal margin
≥
3 dB.
No DSL Loop 1/ Loop 2 sync, errors detected, or signal margin < 3 dB.
DSX/DS1 Green
Red
DSX-1 signal is present, and no errors being detected.
In framed mode, denotes loss of framing or loss of sync at the DSX/DS1
input; in unframed mode, denotes loss of signal at DSX/DS1 input.
ALM Off
Red
Yellow
No active alarm present.
Loss of DSX-1 signal to the unit.
Loss of DS1 signal to the remote.
ESF/SF
Off
Yellow
Green
Unit is provisioned for unframed data.
Unit is provisioned for ESF data.
Unit is provisioned for SF data.
B8ZS/AMI Yellow
Green
Unit is provisioned for B8ZS line code.
Unit is provisioned for AMI line code.
LBK Off
Yellow
Unit is not in loopback.
Unit is in loopback (network and/or customer).
1223404L2
DSX
/DS1
ALM
DSL 1
DSL 2
R
S
2
3
2
LBK
ESF
/SF
B8ZS
/AMI
H TUC
TX
RX
TX
RX
DSX MON
DSX EQ