ADTRAN 1700405G1, Руководство по установке оборудования

Страница: 24 / 30

Unit Installation NetVanta 100 Series Hardware Installation Guide
24 Copyright © 2010 ADTRAN, Inc. 61700412E1-34C
Figure 5. Ceiling Mounting the NetVanta 150 (Side View)
Getting Started
Supplying Power to the WAP
The NetVanta 150 WAP can be powered either by connecting the ETH 0/1 Power over Ethernet ( PoE )
connector to a PoE-capable NetVanta controlling unit or connecting the 12 VDC external power supply to
the
POWER connection. Both of these connectors are on the rear of the unit (see the Figure 2 on page 20 ).
The external power supply is not automatically shipped with the NetVanta 150 WAP but a domestic
(P/N 4700412E1) or international (P/N 4700412E1#IN) bundle containing the appropriate external power
supply can be requested from ADTRAN or your reseller.
Connecting to the WAP
Using the provided Ethernet cable, connect the
ETH 0/1
port on the back of the NetVanta 150 WAP to the
Ethernet port of the NetVanta controlling unit or to an Ethernet port on a unit that can be accessed by the
controlling unit.
The 10/100Base-T Ethernet interface ( ETH 0/1 ) MUST NOT be metallically connected to
interfaces that connect to the outside plant (OSP) or its wiring. This interface is designed
for use as an intrabuilding interface only. The addition of primary protectors is not
sufficient protection to connect this interface metallically to OSP wiring.
1 1
2
Ceiling Tile
Side View
Bracket Detail