Remove the mounting ears. Rotate them 90
o
so that the portion of the bracket with the mounting holes is
flush with the bottom of the chassis, and reattach them to the chassis (see
Decide on a location for the unit. Keep in mind that the unit needs to be mounted at or below eye level so
that the LEDs are viewable.
Important! Mount the chassis with LEDs facing to the side as shown in
(not facing up or
down).
Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick) to a wall
stud using #6 to #10 (2.5-inch or greater in length) wood screws.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
Have an assistant hold the unit in position as you install two #6 to #10 (1-inch or greater in length) wood
screws through the unit’s brackets and into the mounted board. See
Proceed to the steps given in
Supplying Power to the Unit on page 64
.
SL
O
T 2 NE
T/DBU
SL
O
T 1 NE
T/DBU
ET
H
0
/2
ET
H
0
/1
SL
O
T 2 NE
T/DBU
SL
O
T 1 NE
T/DBU
ET
H
0
/2
ET
H
0
/1
Unit Installation
NetVanta 3200/3300/3400 Series
64
Copyright © 2019 ADTRAN, Inc.
61200860L1-34AE
Figure 32. Wall Mounting the NetVanta 3450 and NetVanta 3458
Supplying Power to the Unit
As shipped, each NetVanta 3200/3300/3400 Series is set to factory default conditions. After installing the
base unit and any option modules, the NetVanta is ready to be powered. To power the unit, ensure that the
unit is properly connected to an appropriate power source (as outlined in the sections that follow).
Instructions for Wall Mounting NetVanta 3450/NetVanta 3458
Step
Action
1
2
3
4
5
