ADS-tec StoraXe PowerBooster GSS0608, Руководство пользователя

Страница: 45 / 140

Operating
instructions
Version:1.3 GSS0608 Page 23 of 72
Installation conditions:
• The checklist "Commissioning Requirements" must be completed and signed
(

attachment:
Transport and preliminary information
).
•
The system is only suitable for outdoor installation.
•
Observe the following floor space requirements for the system:
−
The floor space is to be constructed at the installation location in accordance with the local
conditions and technical data (

3.2Technical data ).
− The floor space is exactly horizontal.
− Cable entry is from below.
−
The floor space has the required load capacity for the 1.25 t weight of the system and has to
withstand this load permanently.
If applicable, also take into account the weight of the means of transport.
− Sufficient drainage is available.
• Earthing via ring earth electrode for flexible connection cable (min. 16 mm²) according to national
and local regulations and conditions must be in place.
• Note that ventilation openings must be kept clear.
−
The air at the ventilation openings must be able to circulate freely.
−
During the entire operating time, no leaves, dirt, etc. must be sucked in from the ventilation
openings.
• Protect the system against penetrating water (groundwater or flood hazard area).
• Keep the existing housing doors closed.
• Observe the required minimum distances of 1.5 m to adjacent structures. Make additional spacing
allowances for open doors and any escape routes.
When installing in built-up areas, observe the local noise abatement regulations (Germany: "Technische
Anleitung zum Schutz gegen Lärm" (Technical Instructions for Protection against Noise), abbreviated "TA
Lärm"). Observe the resulting minimum distances to residential buildings.
Power connections:
Note the information in the electrical diagram (

Electrical diagram in manual GSS0608
).
4.9 Standards
Compliance with the protective aims of the applicable CE directives is confirmed by the EU conformity
declaration and is represented by a CE mark on the product. The EU conformity declaration is part of the
documentation.