Industrial PCs IPC1300
16
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
5
S
TARTUP
Caution:
The PC should be switched off before disconnecting plugs in order to avoid damage
to electronic components! In order to avoid formation of condensation, the device
should only be switched on once it has acclimated to the room temperature. Pay
attention to the voltage permitted for the device.
You should allow five seconds to pass between switching the device off and switching
it back on.
5.1
A
VAILABLE INTERFACES
The devices have the following interfaces as standard.
Note:
Cable shielding of a data cable has to be connected to the plug connection casing (EMC).
The interfaces have to be enabled in the embedded operating system and the matching
drivers have to be installed to be able to use the interfaces.
Pos : 20 /D atent ec hni k/I nbetri ebnahme/ Kabelmont age/ Kabelmont age für OPC- Seri e / IPC 5100 / 5300 / 5500 / 1100 @ 0\ mod_1158848147709_681.doc @ 797 @
5.2
C
ABLE INSTALLATION
The device interfaces and power supply plug are found on the side of the casing. The free
slots and the drives are found in the same place.
Pos : 21 /D atent ec hni k/I nbetri ebnahme/R eihenfolg e der Inbetriebnahme/R ei henf olge der I nbetriebnahme f ür I PC 1100 @ 0\ mod_1158850330926_681.doc @ 801 @
5.3
S
TARTUP PROCEDURE
•
Connect device with suitable power source.
•
Connect the cable for serial / parallel data transfer and fasten the plugs to the
sockets.
•
Connect all further required cables and secure against slippage.
Pos : 22 /D atent ec hni k/I nbetri ebnahme/ Betriebsberei tschaf t prüf en/ Betriebsbereit schaf t prüf en f ür O PC/C PC/ PLC /OTC /ITC/ VMT-Serie(+Monit ore) / I PC 5100/ 5500/ 2400/1100 @ 0\ mod_1158905578361_681. doc @ 806 @
