4.
INSTALLATION
(Please also refer to the following drawing)
4.1 Fix the metallic window plate on the rear panel of your computer case.
4.2 Plug the connector of the enclosed “Y” type power cord into the
window plate.
4.3 Plug the connector of the power cord from the UPS with the
matching connector of “Y” power cord.
4.4 The “Y” power cord has 2 outlets for your computer and monitor. To
ensure that your computer will be protected during a utility failure, the
outlets of UPS must be connected with your computer and monitor,
and apply the original power cord of your computer as the input cord of
the UPS. When the connection is completed. The UPS can be turned
on by one touch at the control button on the front panel.
5.
TESTING
YOUR
UPS
5.1
Before test, please have the UPS charged for one day or the time
mentioned in the spec. sheet.
(Do not have to turn on your computer, just keep the city power
connected to the UPS and turn on your UPS – green LED will be on.)
5.2
In normal mode of UPS, turn on your computer, push the UPS button
on the front panel for self-test. If it is OK, green LED will be on.
While if it is over loaded, the UPS will alarm. Or if the battery level is
low, it will emit quick beep for several seconds and stay in normal
mode for recharging.
Please also refer to the, “LED/Alarm Indication” in item 7.5.
5.3 Push the button for 4sec, and check if the UPS can be turned-off
manually.
5.4 Push the button again to turn on the UPS, then UPS will enter
stand-by status, and finish the test.
6.
ERROR MESSAGE OF THE TEST
6.1 During the test, if the UPS emits a quick beep, it means the battery
level is low. Please leave the UPS in normal mode for at least 10
hours, and the batteries will be fully charged.
6.2 If the UPS emits a continuous beep during the test, it may be in an
overload situation. The over load may result in an unexpectedly short
runtime during a blackout. Please turn off the computer and check if
any equipment can be removed from the UPS.
6.3 If the UPS emits a continuous urgent beep for 12 seconds after test,
it means that the batteries are no good and may need replacement.
6.4 Since the UPS is made with frequency auto-select function. Either
50Hz or 60Hz of your city power, the UPS will detect it, and apply the
same frequency in operation. However, if the frequency of city
power is abnormal, outside the range 47 – 65Hz, the UPS will switch
to backup mode for protecting your computer. (Even the city power
voltage is O.K.)
ORIGINAL POWER CORD
OF COMPUTER
METALLIC
WINDOW
PLATE
SWITCHING
SUP
POWER
IEC FEMALE
PLY
IEC FEMALE
TO MONITOR
IF REQUIRED
DB9
IEC MALE
Micro PC series
Micro PC series
3 4
