9
6.2
INSTALLING YOUR CHAIR
To install your chair proceed as follows:
Ensure that there is a power socket available close to where the chair will be placed.
Connect one end of the extension lead into the matching two prong slot in the transformer
block and the other end into the plug situated at the rear of the chair underneath the backflap,
usually held fast by a cleat.
Then connect the mains plug of the transformer into a suitable mains power socket and
switch on the power.
The chair should now operate when the handset buttons are pressed.
WARNING! Always ensure that the plug is undamaged before plugging in to a suitable
240V power supply.
WARNING! All cables and power leads must be positioned in such a way that they cannot
become accidentally trapped in the chair mechanism, run over by the castors or other equipment
such as vacuum cleaners.
WARNING! You must always ensure that leads, cables and all other electric components
are kept dry. Never operate the chair in a damp environment.
WARNING! It is not recommended to use extension leads with this product but plug the
electrical lead directly into the socket.
WARNING! It is important that leads and cables are checked for damage every time the
chair is moved and not less frequently than once a week. If any cables are found to be damaged in
any way it is vitally important that you contact your dealer.
WARNING! Most riser recliners are fitted with a remote transformer block which is
attached to a 13 amp plug. The transformer block must not be allowed to dangle from a high socket.
Always take care not to trip over the block and keep it located in the safest possible position in a
well ventilated, dry place on the floor where it sits on its rubber feet. The transformer reduces the
240V mains power to a safe low voltage of just 24V.
Содержание RISER RECLINER
Страница 1: ...RISER RECLINER USER MANUAL...
Страница 20: ...19...