<1. Introduction>
6
IM 01E25A01-01EN
1.2 Warranty
• The warranty shall cover the period noted on the
quotation presented to the purchaser at the time of
purchase. Problems occurred during the warranty
period shall basically be repaired free of charge.
• In case of problems, the customer should contact
the YOKOGAWA representative from which
the instrument was purchased, or the nearest
YOKOGAWA office.
• If a problem arises with this instrument, please inform
us of the nature of the problem and the circumstances
under which it developed, including the model
specification and serial number. Any diagrams,
data and other information you can include in your
communication will also be helpful.
• Responsible party for repair cost for the problems
shall be determined by YOKOGAWA based on our
investigation.
• The Purchaser shall bear the responsibility for
repair costs, even during the warranty period, if the
malfunction is due to:
- Improper and/or inadequate maintenance by the
purchaser.
- Failure or damage due to improper handling, use
or storage which is out of design conditions.
- Use of the product in question in a location
not conforming to the standards specified by
YOKOGAWA, or due to improper maintenance of
the installation location.
- Failure or damage due to modification or repair
by any party except YOKOGAWA or an approved
representative of YOKOGAWA.
- Malfunction or damage from improper relocation of
the product in question after delivery.
- Reason of force majeure such as fires,
earthquakes, storms/floods, thunder/lightening,
or other natural disasters, or disturbances, riots,
warfare, or radioactive contamination.
1.3 Combination for Remote
Sensor and Remote
Transmitter
IMPORTANT
• The AXW remote sensor (sizes 500 to 1800 mm
(20 to 72 in.)) should be combined with a remote
transmitter according to Table 1.2.
• If the transmitter combined with the AXW magnetic
flowmeter’s remote sensor is changed from the
AXFA11 to AXW4A or vice versa, the meter factor of
the remote sensor must be readjusted according to
its flow calibration.
Table 1.2 Combination for sensor and transmitter
Remote Sensor
Combined with the
Remote Transmitter
Model
Converter,
Communication,
I/O
Model
AXW500G to AXW10LG
AXW500W to AXW10LW -W
AXW4A
AXW500G to AXW18LG
AXW500W to AXW18LW -N
AXFA11G
Contact YOKOGAWA before using it in combination with
transmitters other than those listed above.
NOTE
In case of combination with AXFA11 remote transmitter,
select “ADMAG AXF” in the parameter “C30” of the
AXFA11 remote transmitter.
