Q7-AL
Smart Embedded Management Agent (SEMA)
39
5.1.4.
Exception Codes
In case of an error, the BMC drives a blinking code on the blue Status LED (LED1). The same error code is also
reported by the BMC Flags register. The Exception Code is not stored in the Flash Storage and is cleared when the
power is removed. Therefore, a “Clear Exception Code” command is not needed or supported.
Table 8: SEMA Exception Codes
Exception Code
Error Message
0
NOERROR
2
NO_SUSCLK
3
NO_SLP_S4_S5
4
NO_SLP_S3
5
BIOS_FAIL
6
RESET_FAIL
7
RESETIN_FAIL
8
NO_VIN_PWR_BAD
9
CRITICAL_TEMP
10
POWER_FAIL
11
VOLTAGE_FAIL
12
NO_3V3_5V_A_PG
13
NO_VNN_PG
14
NO_1V24_A_PG
15
NO_VDDQ_PG
16
NO_V1P05S_PG
17
NO_V3P3_S0_PG
18
NO_V12
19
MEMORY_ERROR
20
NO_P3V3_A_READY
5.1.5.
BMC Flags
The BMC Flags register returns the last detected Exception Code since power-up and shows the BIOS in use and
the power mode.
Table 9: SEMA BMC Flags
Bit
Description
[ 0 ~ 4 ]
Exception Code
[ 6 ]
0 = AT mode
1 = ATX mode
[ 7 ]
0 = Standard BIOS
1 = Fail-safe BIOS.
Содержание Q7-AL
