ADLINK Technology NuIPC cPCI-3500A Series, Руководство пользователя

Страница: 27 / 42

Hardware Installation
•
21
2.6 HDD Removal and Installation
In cPCI-3500A, user can install one 2.5 inches HDD or flash disk. The
modules with standard configurations are equipped with 2.5 inches HDD,
and the capacity of the HDD is upon request.
HDD Removal for cPCI-3500A
To remove the HDD, please follow this procedure
•
Remove the FDD
•
Remove whole FDD drive bay and the 3
rd
-slot front panel by removing
3 or 4 screws
•
Remove the 4 copper stand-off between FDD drive bay and HDD
drive holder plate
•
Disconnect the HDD cable (44-pin)
•
Remove the 3 screws on the top of HDD drive holder plate, remove
the 2 screws on the front panel, then you can remove the whole HDD
with the drive holder plate
•
Remove the 4 screws, which lock the HDD on the drive h older plate.
Then the HDD is de-attached
HDD Installation for cPCI-3500A
•
Lock the HDD on the drive holder plate. Please note the orientation
of the HDD. The HDD’s pin #1 must match the location of IDE
connector pin #1
•
Install the HDD with the drive holder plate on the module. Lock the 2
screws on the front panel, and 3 screws on the drive holder plate.
•
Connect the 44-pin HDD cable (44-pin), check if pin #1 of the IDE
connector, cable and the HDD are matched
•
Screw 4 copper stand-off on HDD drive holder p late
•
Put FDD drive bay with the 3
rd
-slot front panel, screw the FDD drive
bay with the copper stand-off on HDD drive holder plate
•
Put FDD on drive bay and screw the four screws
StockCheck.com