ADLINK Technology MPC-8164, Руководство пользователя

Страница: 128 / 311

116 Operation Theory
4.4 Counters
There are four counters for each card axis:
X
Command position counter : counts the number of output
pulses
X
Feedback position counter : counts the number of input
pulses
X
Position error counter : counts the error between com-
mand and feedback pulse numbers.
X
General purpose counter : The source can be configured
as pulse output, feedback pulse, manual pulser, or CLK/2.
X
Target position recorder , a software-maintained target
position recorder, is discussed.
4.4.1 Command position counter
The command position counter is a 28-bit binary up/down counter.
its input source is the output pulse from the 8164, thus, it provides
accurate information of the current position. Note: the command
position is different from target position. The command position
increases or decreases according to the pulse output, while the
target position changes only when a new motion command has
been executed. The target position is recorded by the software,
and needs manually resetting after a home move is completed.
The command position counter will clear (reset to “0”) automati-
cally after a home move has completed. The function
_8164_set_command()
can be executed at any time to set a
new command position value. To read current command position
use
_8164_get_command()
.
Related functions:
X
_8164_set_command(), _8164_get_command(): Refer to
section 6.15