ADLINK Technology LEC-BT, Техническое описание

Страница: 10 / 46

4 Overview
1.3 Connectors, Switches, and LEDs
Table 1-2 describes the connectors, switches, and LEDs shown in Figure 1-4.
Table 1-2: Module Connector Description
Connector#
Board
Access
Description
GF1 – SMARC P-S Top/
Bottom 314-pin, MXM edge connector for routing Camera,
Graphics, and I/O signals from the module to the baseboard
CN1 Top 40-pin, DB40 connector for debug card
SW1, SW2, SW3 – 4-pin dip
switches for enabling/
disabling CSI1 camera, 4L,
Data 0-3 [default=ON/ON] Top
SW1-SW3 CSI1 Settings :

One-lane CSI1 configuration (CSI1-D0) -
Set SW1, SW2, and SW3 to ON/ON
 Two-lane CSI1 configuration (CSI1-D0
and CSI1-D1) - Set SW1 to OFF/OFF
and leave SW2 and SW3 ON/ON [fac-
tory default]

Three-lane CSI1 configuration
(CSI1-D0, CSI1-D1, and CSI1-D2) - Set
SW1, SW2 to OFF/OFF and leave SW3
ON/ON
 Four-lane CSI1 configuration (CSI1-D0,
CSI1-D1, CSI1-D2, and CSI1-D3) - Set
SW1, SW2, and SW3 to OFF/OFF
SW4 Top 4-pin dip switch for:
• Loading BIOS setup defaults at Boot Up (2=off [default],
3=on)
• Selecting 18/24 bit LVDS modes (1=18bit [default],
4=24bit)
ON 1 2
(1 2)
LEC-BT_SW1_e
(4 3)
SW1 Switch Default Setting
ON
1 2
(1 2)
LEC-BT_SW2_SW3_a
(4 3)
SW2, SW3 Switch Default Settings
ON
1 2
(1 2)
LEC-BT_SW4_c
(4 3)
SW4 Switch Default Setting