ADLINK Technology cPCIS-6418U Series, Руководство пользователя

Страница: 16 / 66

8 Getting Started
The handles on CompactPCI cards and PSUs ensure simple and
safe installation and removal. Please follow the procedures below
to install a CompactPCI module into a chassis:
1. Place the subsystem on a level surface or rackmount it.
Remove the blanking plates where required by undoing
the retaining screws at each end. Retain the blanking
plates for possible future use. The system should not be
put into use without blanking plates for all empty slots,
otherwise the EMC and cooling performance will be
compromised.
2. Hold the SBC module or peripheral card horizontally.
Make sure that the handles are unlatched (i.e. that they
are spread outwards). If necessary, unlatch the handle
by pressing on the release button with your thumb.
Figure 2-1: Installing a 6U SBC module
3. Carefully insert the module into the desired slot by slid-
ing the edges of the board into the appropriate card
guide rail. Take care to ensure correct alignment of the
card with the chassis during insertion to prevent damage
to the card and/or backplane.