Product Overview
11
CM1-86DX3
1.8
Getting Started
This section provides the most efficient way to setup and power on your CM1-86DX3 SBC.
Select a clean flat, anti-static work surface for setup and operation, large enough to include any
external peripherals and optional devices.
Use the cable set provided by ADLINK Technology to connect the CM1-86DX3 to a VGA moni-
tor. Connect either PS/2 or USB keyboard or mouse, respectively. Use the SATA cable to con-
nect the hard disk. Make sure that the pins match their counterparts correctly and are not
twisted. If you plan to use additional peripherals, connect them to the appropriate headers.
Connect a 5 volt, 5 amps power supply to the power connector and switch on the power.
The display shows the BIOS messages. If you want to change the standard BIOS settings,
press the <DEL> key to enter the BIOS setup menus. See Chapter 4 for setup details.
If you need to load the BIOS default values, they can be automatically loaded at boot time.
The CM1-86DX3 boots from CD drives, USB sticks, hard disks, or µSD-Cards. Provided that
any of these is connected and contains a valid operating system image, the display then shows
the boot screen of your operating system.
The CM1-86DX3 needs adequate cooling measures depending on the desired operating tem-
perature range. Using the board without cooling could damage the board permanently.
Be sure to observe ESD prevention measures. Make sure you are
always at the same potential as the module.
Assurez-vous de respecter les mesures de prévention des décharges
électrostatiques. Assurez-vous que vous êtes toujours au même
potentiel que le module.
Never connect or disconnect peripherals like HDDs while the power
supply is connected and switched on.
Ne connectez ou ne déconnectez jamais des périphériques tels que
des disques durs lorsque l'alimentation est connectée et sous tension.
The 5 amps value is the minimum you should have for the standard
peripherals mentioned. For additional peripherals, make sure enough
power is available. The system will not work if there is not enough
supply current for all your devices.
MISE EN GARDE
MISE EN GARDE
Содержание CM1-86DX3
Страница 18: ...12 Product Overview This page intentionally left blank...
Страница 28: ...22 Hardware This page intentionally left blank...
Страница 38: ...32 Interfaces This page intentionally left blank...
Страница 58: ...52 This page intentionally left blank...