ADLINK Technology cExpress-AL, Руководство пользователя

Страница: 68 / 106

62
BIOS Setup
Feature Options Description
COM4 Info only
Console Redirection Enabled
Disabled
Console Redirection Enable or Disable.
Console Redirection Settings Submenu The settings specify how the host computer and the
remote computer (which the user is using) will
exchange data.
Both computers should have the same or compatible
settings.
The item will be lunched before enable Console
Redirection.
Legacy Console Redirection Info only
Legacy Console Redirection
Settings Submenu Legacy Console Redirection Settings
7.3.9.1. Advanced > Serial Console Redirection > Console Redirection Settings (if COM1 enabled)
Feature Options Description
COM1 Info only
Console Redirection Settings Info only
Teriminal Type
VT100
VT100+
VT-UTF8
ANSI
Emulation:
ANSI: Extended ASCII char set.
VT100: ASCII char set.
VT100+: Extends VT100 to support color, function
keys, etc.
VT-UTF8: Uses UTF8 encoding to map Unicode chars
onto 1 or more bytes.
Bits per second 9600
19200
38400
57600
115200
Selects serial port transmission speed. The speed
must be matched on the other side. Long or noisy
lines may require lower speeds.
Data Bits 7
8
Data Bits
Parity
None
Even
Odd
Mark
Space
A parity bit can be sent with the data bits to detect
some transmission errors.
Even: parity bit is 0 if the num of 1's in the data bits is
even.
Odd: parity bit is 0 if num of 1's in the data bits is odd.
Mark: parity bit is always 1.
Space: Parity bit is always 0. Mark and Space Parity
do not allow for error detection.They can be used as
an additional data bit.
Stop Bits
1
2
Stop bits indicate the end of a serial data packet. (A
start bit indicates the beginning). The standard setting
is 1 stop bit. Communication with slow devices may
require more than 1 stop bit.
Flow Control
None
Hardware RTS/CTS
Flow control can prevent data loss from buffer
overflow. When sending data, if the receiving buffers
are full, a 'stop' signal can be sent to stop the data
flow. Once the buffers are empty, a 'start' signal can
be sent to re-start the flow. Hardware flow control uses
two wires to send start/stop signals.
VT-UTF8 Combo Key Support
Enabled
Disabled
Enable VT-UTF8 Combination Key Support for
ANSI/VT100 terminals