Page 30
AmITX-HL-G
4.2.13.
SPI Header
2x6-pin 2.0 pitch standard wafer connector
Type Signal
Pin # Pin # Signal
Type
CLK
1
2
SB3V3
PWR
I CS0#
3
4 ADDIN
IO
I CS1#
5
6 NC
-
I MOSI
7
8 ISOLATE IO
O MISO
9
10 GND
PWR
IO SPI_IO2_#WP
11
12 SPI_IO3_#HOLD IO
Signal
Description
CLK Serial
Clock
SB3V3
3.3V Standby Voltage power line. Normally output power, but when Motherboard is turned off then the on-board
SPI Flash can be 3.3V power sourced via this pin.
CS0#
CS0# Chip Select 0, active low.
ADDIN
ADDIN input signal must be NC.
MOSI
Master Output, Slave Input
ISOLATE#
The ISOLATE# input, active low, is normally NC, but must be connected to GND when loading SPI flash. Power
Supply to the Motherboard must be turned off when loading SPI flash. The pull up resistor is connected via diode
to 5VSB.
MISO
Master Input, Slave Output
SPI_IO2_#WP
SPI Data I/O: A bidirectional signal used to support the new Dual
IO Fast Read, Quad IO Fast Read and Quad Output Fast Read modes. This signal is not used in Dual Output
Fast Read mode.
SPI_IO3_#HOLD SPI Data I/O: A bidirectional signal used to support the new Dual
IO Fast Read, Quad IO Fast Read and Quad Output Fast Read modes. This signal is not used in Dual Output
Fast Read mode.
1 2
Содержание AmITX-HL-G
Страница 2: ...Page 2 AmITX HL G Revision History Revision Description Date By 1 00 Initial release 2015 11 24 JC ...
Страница 15: ...AmITX HL G Page 15 3 2 Mechanical Dimensions Top View Dimensions mm All tolerances 0 2mm ...
Страница 16: ...Page 16 AmITX HL G Side View Dimensions mm All tolerances 0 2mm ...