Adler AD 7921, Руководство пользователя

Страница: 5 / 80

5
2 1 . Do not place any objects on the device.
2 2 . The device can be used only with properly working ventilation.
DEVICE DESCRIPTION (Fig. A)
1. Upper cover
2. Upper water tank
3. Plastic containers to frozen the water inside
4. Louver
5. Air outlet
6. Bottom water tank
7. Water level indicator
8. Casters
9. Control panel
10. Power cord
11. Mesh filter
12. Drain plug
13. Evaporation paper filter
14. Remote control
15. Bracket
CONTROL PANEL DESCRIPTION (Fig. C)
A. Power switch ON/OFF
B. Cooling / Humidify button
C. Mode choice button
D. Horizontal air osculation button
E. Fan speed button
F. Timer button
G. Slow fan speed indicator
H. Medium fan speed indicator
I. Fast fan speed indicator
J. Normal air wind mode
K. Natural air wind mode
L. Sleep wind mode
M. Power indicator
N. Horizontal air osculation indicator
A noticeable reduction in the temperature of the outlet air occurs after putting into the water tank plastic containers attached to the
product previously frozen in the freezer. Those 2 plastic containers can use circularly. The content of plastic container is prohibited to
edible. It is recommended to fill the tank with cold tap water.
Installation instructions for casters:
Take out the 4 casters from package. Turn the device upside down, align the caster shaft with the caster installation hole in the body
bottom and press firmly to the end. Look at figure B.
USING THE DEVICE
Buttons on remote control (14) is same as the control panel (9). Don’t put any stuff in the front of the remote control's receptor.
1. Place the device on a dry, flat surface.
2. Open upper cover (1) and pour the water to MAX level at water level indicator (7). Connect the device to the power supply.
3. Turn on the device using the power switch (A) button on the control panel (Fig. C). default setting is middle fan speed. Press power
switch (A) again, product is in standby.
4. The fan speed button (E) on the control panel (9) allows you to change the speed of the fan. The following fan speeds can be selected
by pressing again: medium (H) -> slow (G) -> fast (H) -> medium (H) -> …
5. Cooling / Humidify button (B) lowers the temperature of the air by running the water pump. Additionally, you can put to upper water
tank (2) attached plastic containers (3). Plastic containers (3) should be filled up to max level by water and frozen in the freezer in
advance.
To blow the cool air, the device must be filled with water. When the device is operating, periodically check the water level to see whether
to add water. NEVER switch on the water pump when the bottom water tank (6) is not filled by water to minimum level at least.
6. Pressing the horizontal air osculation button (D) to start the oscillation of slats that provide even distribution of cold air stream in range
70°. Horizontal louvers (4) do not move automatically, so if necessary, manually adjust them to point up or down.
7. The TIMER button (F) allows for programming the amount of time during which the device will operate before turning itself off
automatically. Available time period selection is: 2-4-6-8-10-12 hours.
8. The mode choice button (C) allows for changing the fan mode. In addition to the normal fan air wind mode, you can select natural and
sleep modes.
Normal fan mode (J) allows to set up fan speed between: medium (H) -> slow (G) -> fast (H) -> medium (H) -> … Each time the fan is
turned on again it will start operation in normal mode.
The natural mode (K) mimics the natural wind action by repeating the fan speed sequence:
-on fan speed set to low speed (G): the fan will blow 5 seconds at low speed and turn off for 5 seconds and next repeat this cycle;