Adler Europe AD 7727, Руководство пользователя

Страница: 7 / 92

7
DEUTSCH
ALLGEMEINE SICHERHEITSVORSCHRIFTEN LESEN SIE AUFMERKSAM WICHTIGE
ANWEISUNGEN BEZÜGLICH DER SICHERHEIT DER BENUTZUNG BEWAHREN SIE
DIESE FÜR DIE ZUKUNFT AUF
Bei Verwendung des Gerätes zu gewerblichen Zwecken werden die Garantiebedingungen
geändert.
1.Vor dem ersten Gebrauch, die Bedienungsanleitung lesen und die dort angegebenen
Hinweise beachten. Der Produzent trägt keine Verantwortung für Schäden, die aufgrund
von bestimmungswidriger Nutzung oder unsachgemäßer Bedienung entstanden sind.
2.Das Gerät ist nur für den Hausgebrauch verwendet. Verwenden Sie es nicht für andere
Zwecke als den bestimmungsgemäßen Gebrauch.
3.Das Gerät ausschließlich an die Steckdose 220-240 V - 50/60 Hz anschließen. Es darf
nicht zu anderen, bestimmungswidrigen Zwecken benutzt werden. Wegen
Vorsichtsmaßnahmen, sollten keine weiteren Geräte an den gleichen Stromkreis
angeschlossen werden.
4.Falls sich Kinder in der Nähe befinden, sollte bei der Nutzung des Gerätes spezielle
Vorsicht bewahrt werden. Dieses Gerät ist nicht zum Spielen für Kinder, sowie für
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment.
Do not dispose this appliance in the common waste bin.
DEUTSCH
high heating power. The ECO function will compare the target temperature with the current room temperature, and it will automatically
select the most appropriate heating level to guarantee an optimum comfort level while reducing the energy consumption. While the ECO
function is switch on, your heater may switch automatically to low or high heating level even several time.
8. Press the oscillation button (2E), your heater will oscillating horizontally from left side to right side, press the button again to stop
oscillation.
9. Press the temperature decreasing button (2F) or press the temperature increasing button (2G) to set the temperature from 10°C to
35°C . When you set the temperature, the temperature digital icon (1H) will shows the temperature you selected. And after 5 seconds,
the digital icon (1H) will show the room temperature again.
10. To turn off your heater, press the ON/Stand-By Button(2A). If your heater is working on heating mode, press the ON/Stand-By
Button(2A), your heater will working on fan mode for 30 seconds and the digital icon will countdown from 30 to 0 in order to cool down
components. Unplug the device when it is not in use.
11. Remote control (8) operation is same as manual operation of buttons on control panel (2).
To use the device with the remote control (8) supplied, pull the installing film. In order to remove the battery, simply squeeze the small tab
and pull. To replace the battery, insert 1 x CR2025 (3V) lithium battery into the small crevice.
IMPORTANT: The + symbol on the battery inserted should be facing upwards. Firmly close the battery compartment to begin using the
remote control (8)
OVER-TIP PROTECTION
The device is protected with a safety switch - named tip-over switch (5) - that turns off the device automatically when the heater falls
over, or is at an excessive angle from the horizontal. This helps prevent accidents, and the heater will back to the standby mode. Press
the buttons (2A) on control panel to reset the device.
OVERHEATING PROTECTION
1. In the event of accidental overheating (for example: obstruction of air intake and outlet grilles, motor turning slowly or not at all), a
safety device shuts down the heater automatically. To reset, disconnect the plug from the power for a few minutes, remove the cause of
overheating then plug the device in again.
2. If you still notice the same defect as above mentioned, remove the plug from the socket and consult your authorized dealer to your
after-sales service department.
3.During use, do not touch or cover the air outlet. This may cause the unit to overheat, and the safety device to operate.
CLEANING AND MAINTENANCE
1.The device must be switch OFF via the power switch (7) and unplugged before proceeding with any cleaning work. Let the device to
cool down some minutes before start the cleaning.
2.Clean the housing with a lightly damp cloth, a vacuum cleaner or a dusting brush.
3.Never use flammable or abrasive cleaning agents such as benzene or spirit to clean the appliance.
4.Never immerse the appliance in water!
5.Clean the air inlet and outlet regularly with a vacuum cleaner.
6.If the appliance is not used for an extended period it must be protected against excessive dust and dirt. Store the heater in a dry place
away from sunlight and dirt.
TECHNIAL DATA
Power 1500W
Power supply 220-240V ~50/60Hz