Adler Europe AD 4497, Руководство пользователя, Страница: 4 / 60

4
c. Whisk for heating milk d. Maximum filling level mark
16. To avoid being splashed with milk or foam (which may be hot), always put the lid on the
milk frother before you switch it on.
g. Control button h. Power base
2. Filling level indicators
INSTRUCTIONS FOR USE
1.Choose the whisk for the desirable effect. Whisk for milk frothing (1b). If you want your milk frothed. Whisk for heating the milk (1c). If
you want your milk heated. You can also use this whisk (1c) if you want to prepare hot chocolate.
NOTE: If you have chosen to heat the milk, take off the spring from the whisk.
2. Pour in a portion of milk (preferably 3.2% fat). The milk should cover the whisk (1b or 1c), and reach marked minimum level but not
exceed the maximum level mark (1d). Maximum level for milk heating is 300ml (2a) and for milk frothing is 120ml (2b).
NOTE: For best results use cold, fresh milk. Non-dairy milk doesn't froth as well as dairy milk. For best effect use “barista” type plant
based milk.
14. For additional protection, it is advisable to install a residual current device (RCD) in the
electrical circuit with a rated residual current not exceeding 30 mA. A specialist electrician
should be consulted in this regard.
15. NOTE: The milk frother has a heating function. Be very careful while opening the lid
and pouring milk in so as to avoid getting burnt.
17. Hold the milk frother by the handle ( 1e ). The pot housing becomes hot during
operation.
1. DESCRIPTION
a. Lid b. Whisk for milk frothing
a. MAX level for heating milk (300ml)
b. MAX level for cold / hot milk frothing (120ml)
e. Handle f. Milk jug
5. The appliance will run until a high temperature of milk is reached. The LED light will flash 10 seconds to indicate the work is done and
then go off.
5.You can also clean the frother by pouring water into it and running it for one cycle (this prevents the whisk from blocking by milk
sediments accumulating on the agitator shaft seal).
1.Before washing the appliance, make sure it cooled down and is disconnected from the power socket.
CLEANING AND MAINTENANCE
Power supply: 220-240V ~50/60Hz
TECHNICAL DATA:
6. To turn off the appliance before the end of the cycle, press the control button (1g) during work.
NOTE: Milk heats to approximately 50-65°C. This temperature ensures the best flavor of the coffee.
Power: 600W
NOTE: Do not exceed the MAX line inside the jug.
Maximum power: 1000W
2.Always remove the jug from the power base before cleaning.
IMPORTANT: Do not put milk frother bottom into water. Do not put entire jug into water.
4. Touch control button once (1g) if you want to heat and froth your milk (with whisk 1b) or if you just want to heat the milk (with whisk 1c).
Touch control button twice if you want to get a non-heated frothed milk (only with whisk 1b).
Capacity: frothed: 120ml / heated: 300ml
3. Put the lid (1a) on the jug and place the jug on the power base (1h).
3.The device should be washed after each use.
4.Clean jug with a soft cloth and washing-up liquid.
NOTE: The milk frother is non dishwasher-safe.
ingredients may pose a threat to the environment. The electrical device should be handed over to limit
Worn device should be returned to the appropriate point storage because it is dangerous in the device
its reuse and use. If in the device there are batteries you have to take out and give to the point stored separately.
Please transfer cardboard packaging to waste paper. Pour the polyethylene bags (PE) into the plastic container