Keypad & Proximity Flash Mount Reader Installation Manual
Model：ADK-DTA16/AC
Mounting:
1.
Install the metal plate on the wall with two or four screws, which depends on different kinds of gang box
being installed.
2.
The cover shall clip on the upper edge first and then push in the bottom part.
3.
Tighten the secure non-dropout screw, which located underneath of the reader to fix the reader and the
back plate.
4. Installation
completed.
Recommendation:
1.
Linear DC Power Supply;
2. 22AWG shielded cable; it’s required to do “one-point” ground. (As shown in the diagram)
Dimension (mm)
Power up Sequences:
1.
When reader is powered up, the Red LED will flash once, then the Green LED will flicker for 5times. The
reader will beep twice and the reader is in Ready mode. Red LED will continue to be ON.
2.
Present the card. The Green LED will flash once; buzzer will beep once.
3.
When keypad is being pressed, Green LED will flash once, buzzer will beep once.
Wiring:
Color
Description
Red
Power Supply to the reader
Black
Signal GND
Green
Wiegand Output data, D0
White
Wiegand Output data, D1
Blue
Green LED control, active low
Brown
Buzzer input, active low
Troubleshooting:
Trouble List
Solution
No Response
when Power Up
Discount the power and confirm that the power supply cable is correctly
connected (See “Wiring” above).
Check the input voltage is sufficient (See “Specifications” above).
Auto Restart
Check the input voltage is sufficient (See “Specifications” above).
Cannot read card
number correctly
Check the format setting on the controller if it is the same as the card format.
Use approved card (known format and Facility Code) to test.
Check if the shield cable is correctly connected to Classis Ground at ONE
point only.
Reader beeps but
No card data info
Check if data 0 & data 1 cable is correctly connected (See “Wiring” above).
Check the input voltage at the card reader end is correct (See “Specifications”
above).
Buzzer error
Check if the buzzer cable is correctly connected (See “Wiring” above).
LED Status Error
Check the Led cable is correctly connected (See “Wiring” above).
Use Default Configuration Card to set it back to normal.
Input Voltage (at Reader end)
DC10V~15V
Typical Read range
> 5cm
Operating Current
100mA (max)
Maximum Cable Length
150m
Operating Temperature
-30ºC~70 ºC
Number pad format
8 bits burst by default
Humidity Range(%)
10-90
Main
Board
