ADJ Products, LLC - www.adj.com - WiFly EXR Dotz Par User Manual Page 16
ADJ Products, LLC - www.adj.com - WiFly EXR Dotz Par User Manual Page 17
WiFly EXR Dotz Par Dotz Par RF Remote
The WiFly EXR Dotz Par RF remote
has many different functions and
allows you to control your WiFly EXR Dotz Par from long distance.
The remote can control your system up to 25 meters. To use the re-
mote you must first activate the fixtures receiver, to activate the re-
ceiver please see the instructions on page 13.
BLACkOUT
-
Pressing this button will blackout the fixture.
FADE -
Press this button to activate fade speed adjustment and use
the “+” and “-” buttons to adjust the fade speed.
COLOR -
This button will activate the color macro mode. Use the
“+” and “-” buttons to scroll through the colors and find your desired
color.
PROGRAMS -
This button will activate the built-in programs mode.
Use the “+” and “-” buttons to scroll through the 4 programs.
SOUND ACTIVE -
This button activates sound active mode.
AUTO RUN
-
Press this button to activate color change speed adjust-
ment and use the “+” and “-” buttons to adjust the change speed.
WiFly EXR Dotz Par Battery Power, Status & Charging
Battery On/Off Switch:
The Battery on/off switch is located underneath the unit next to
I.E.C. power input.
Battery Status:
The LED indicators located on the control panel will allow you
to see the status of the battery life. If all four LEDs are lit you are
at 100%. 3 LEDs is 75%, 2 LEDs is 50%, and 1 LED is 25%.
Please do not let the battery fully die, this severly shortens
the life of the battery.
Battery Recharge: To recharge the battery, switch off the battery
on/off switch. Plug the provided I.E.C. power cord into a power
outlet. When the charge indicator LED is red, the unit is charging.
When the charge indicator LED turns green, it means that the
battery is at full charge.
Master-Slave Operation:
This function will allow you to link up to 16
units together and operate without a controller. In a Master-Slave set
up one unit will act as the controlling unit and the others will react to the
controlling units programs. Any unit can act as a Master or as a Slave.
You can also use WiFly in Master-Slave configuration, so that you do
not need the use of XLR cables.
1. Using approved DMX data cables, daisy chain your units together
via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector is
the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit, set your desired operating mode.
3. On the slave units press the MODE button until “Slave Mode” is
displayed.
WiFly Set Up:
This feature will let you link units to run in a master-
slave mode without the use of XLR cables.
1. Follow the instructions on page 14 to set the wireless address.
The addresses on each fixture must be the same.
2. After you have set the wireless addresses, select your “Master”
unit and set your desired operating mode.
3. On the slave units press the MODE button until “Slave Mode” is
displayed.
4. If everything is set up correctly, the “Slave” units will start follow-
ing the “Master” unit.
WiFly EXR Dotz Par Master-Slave Configuration
