ADJ Startec RAYZER, Инструкция пользователя, Страница: 15 / 26

ADJ Products, LLC - www.adj.com - Rayzer User Manual Page 14
DNST
- This mode is used as a precaution mode, that in case the DMX signal is lost, interrupted,
or power is lost. The operating mode chosen in this setup is the running mode the fixture will go
into when the DMX signal is lost. You can also set this as the operating mode you would like the
unit to return to when power is applied.
1. Press the MENU button until “ DNST ” is displayed, and either “ MASL ”, “ BLND ”, or “ LAST ” will be
displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use the UP or DOWN buttons to choose an
operating mode you would like the unit to start up in when power is applied or the DMX signal is lost.
•
LAST - If the DMX signal is lost the fixture will stay in the last DMX setting. If power is applied and
this mode is set, the unit will automatically go into the last DMX set up.
•
MASL (Master Slave) - If the DMX signal is lost or power is applied, the unit will automatically go into
Master Slave mode and run a built-in show.
•
BLND (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into stand by
mode.
3. Press ENTER to confirm your desired set up.
DISP -
This function will reverse the display 180º.
1. Press the MENU button until “ DISP ” is displayed, press ENTER.
2. Press ENTER to “flip” the display. Press ENTER to “flip” it again.
LED -
With this function you can have the LED display turn off after 10 seconds.
1. Press the MENU button until “ LED ” is displayed, press ENTER.
2. The display will show either “ ON” or “OFF ”. Press the UP or DOWN buttons to select “ ON ” to
keep the LED display on at all times, or “ OFF ” to switch to have the LED display switch off after 10
seconds.
3. Press ENTER to confirm. To make you LED display reappear again press any button.
TEST
- This function will run a self test program.
1. Press the MENU button until “ TEST ” is displayed, press ENTER.
2. The fixture will now run a self test.
FHRS
- With this function you can display the running time of the unit.
1. Press the MENU button until “ FHRS ” is displayed, press ENTER.
2. The running time of the fixture will now be displayed. Press MENU to exit.
VER
- Use this function to display the Software version of the unit.
1. Press the either the MENU button until “ VER ” is displayed, press ENTER.
2. The display will show the software version.
Rayzer Operating Instructions