ADJ Products, LLC - www.adj.com - Saber Spot RGBW Instruction Manual Page 10
ADJ Products, LLC - www.adj.com - Saber Spot RGBW Instruction Manual Page 11
DimCurve -
This will let select your desired dimmer
curve.
1. Press the MENU button until “
DimCurve
” is displayed, and
press ENTER. 1 of 5 dimmer curves will be displayed.
“
STANDARD
”, “
STAGE
”, “
TV
”, “
ARCHITEC
” (Architectural), or
“
THEATRE
”. See the dimmer curve chart on page 28 for more
info.
2. Press the UP or DOWN buttons to find your desired dimmer
curve and press ENTER to confim
.
NO DMX
- This mode can be used as a precaution mode,
that in case the DMX signal is lost, interrupted, or power is
lost, the operating mode chosen in the setup is the running
mode the fixture will go into when the DMX signal is lost. You
can also set this as the operating mode you would like the
unit to return to when power is applied.
1. Press the MENU button until “
NO DMX
” is displayed, and
either “
Look
”, “
Blackout
”, or “
Hold
” will be displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use
the UP or DOWN buttons to choose an operating mode you
would like the unit to start up in when power is applied or the
DMX signal is lost.
•
Look
(Master Slave) - If the DMX signal is lost or power is
applied, the unit will automatically run a built-in show.
•
Blackout
- If the DMX signal is lost or interrupted, the unit will
automatically go into stand by mode.
•
Hold
- If the DMX signal is lost the fixture will stay in the last
DMX setting. If power is applied and this mode is set, the unit will
automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
Saber Spot RGBW
System Menu
RESET
- This function will return the unit to its default
settings.
1. Press the the MENU button until “
RESET
” is displayed and
press ENTER.
2. The display will show either “
NO”
or
“YES
”. Press the UP or
DOWN buttons so that “
YES
” is displayed. Press ENTER and
the unit will reset back to default settings.
MANUAL
- This function will allow you to manually
adjust each LED output intensity and strobe rate. This func-
tion is also a manual testing mode.
1. Press the MENU button until “
MANUAL
” is displayed, press
ENTER.
2. Using the UP or DOWN buttons scroll to the Strobe setting
and press ENTER. Use the UP or DOWN buttons to set the
strobe setting to “255”, and press ENTER again
3. After you have set the strobe setting to “255”, you can use
the UP or DOWN buttons to scroll through RGBW colors. When
you find a color you wish to adjust press ENTER. Now use the
UP or DOWN buttons adjust the colors intensity, press ENTER
once you get your desired intensity. Continue to adjust the
RGBW colors until you have created your desired color.
4. If you would like the unit to strobe, scroll back to the strobe
setting and press ENTER. Use the UP or DOWN buttons to
adjust the strobe rate. Press ENTER once you have found your
desired strobe rate.
Saber Spot RGBW
System Menu