ADJ Products, LLC - www.adj.com - Ricochet Instruction Manual Page 11
Sound Sense
- In this mode you can adjust the sound
sensitivity of the sound active mode.
1. Press the MENU button until “Sound Sense” is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (the lowest) and
100 (most sensitive).
3. Press ENTER to set you desired level.
DMX Last State
- This mode can be used as a precau-
tion mode, that in case the DMX signal is lost, interrupted, or
power is lost, the operating mode chosen in the setup is the
running mode the fixture will go into when the DMX signal is
lost. You can also set this as the operating mode you would
like the unit to return to when power is applied.
1. Press the MENU button until “
DMX Last State
” is displayed,
and press ENTER. The current last state setting will be displayed.
2. Use the UP or DOWN buttons to find a mode you would like
the unit to go into in case the DMX signal is lost.
•
Master/Slave
- If the DMX signal is lost or power is applied,
the unit will automatically go into Master Slave mode and run a
built-in show.
•
Blackout
- If the DMX signal is lost or interrupted, the unit will
automatically go into stand by mode.
•
Last State
- If the DMX signal is lost the fixture will stay in the
last DMX setting. If power is applied and this mode is set, the unit
will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
ADJ Products, LLC - www.adj.com - Ricochet Instruction Manual Page 10
Ricochet
System Menu
Back Light
- With this function the display back light
will turn off after 2 minutes.
1. Press the MENU button until “Back Light” is displayed, press
ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or
DOWN buttons to select “ON” to keep the LED display on at all
times, or “OFF” to allow the LED display to turn off after 2 min-
utes. Press any button to turn on the LED display again.
3. Press ENTER, and then press and hold the MENU button
for at
least three seconds
to confirm.
Pan Invert
- Pan Inversion
1. Press the MENU button until “Pan Invert” is displayed, press
ENTER. Either “Normal” or “Invert” will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until “Invert” is displayed, press ENTER to confim. To deacti-
vate Pan inversion, select “Normal” and press Enter.
Tilt 1 Invert
- Tilt Inversion
1. Press the MENU button until “Tilt 1 Invert” is displayed,
press ENTER. Either “Normal” or “Invert” will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until “Invert” is displayed, press ENTER to confim. To deacti-
vate Tilt inversion, select “Normal” and press Enter.
Auto Test
- This function will run a self test program.
1. Press the MENU button until “Auto Test” is displayed, press
ENTER.
2. The fixture will now run a self test. Press the MENU button to
exit.
Ricochet
System Menu
