ADJ REV186, Руководство пользователя, Страница: 9 / 18

ADJ Products, LLC - www.adj.com - Revo 4 IR User Manual Page 9
System Menu: When confirming your setting press ENTER and then hold MENU for at least
2-3 seconds, or you can wait 1 minute for automatic setup. To exit without making any adjust-
ments press the MENU button.
ADDR - DMX Address Setting.
1. Press the MENU button until “ADDR” is displayed, press ENTER.
2. The current DMX address will now be displayed and flashing. Press the UP or DOWN buttons to
find your desired address. Press ENTER to set your desired DMX address.
NOTE: If after you connect your DMX controller the unit does not fall into DMX mode, press and
hold the MENU button for at least 3 seconds.
CHND - This will let you switch between 4 Channel DMX mode and 256 Channel DMX mode.
1. Press the MENU button until “CHND” is displayed, press ENTER. Either “4CH” or “256C” will be
displayed.
2. Press the UP or DOWN buttons to choose your desired DMX mode and press ENTER to confim
and exit.
SCND - This will let you set unit as a primary or secondary in a primary/secondary configura-
tion.
1. Press the MENU button until “SCND” is displayed, press ENTER. “PRI”, “SEC 1” or “SEC 2” will
be displayed.
2. Press the UP or DOWN buttons until your desired setting is dis-played, press ENTER to confirm
and exit.
SHND: SH 0 - SH 12 - Show modes 0 - 12
Show Mode can run with or without sound active mode on.
With sound active mode on, the shows will tend to run faster.
1. Press the MENU button until “SHND” is displayed, press ENTER.
2. “Sh X” will now be displayed, “X” representing a number between 0-12. Programs 1-12 are preset
shows, while “Sh 0” is random mode. Press the UP or DOWN buttons to find your desired show
and press ENTER to confirm.
3. Press ENTER to confirm, and then press and hold the MENU button for at least 3 seconds.
SOUN - In this mode you can run the unit in sound active mode.
1. Press the MENU button until “SOUN” is displayed, press ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or DOWN buttons to select one or the
other.
3. When you have made your selection, press the ENTER, and then press and hold the MENU
button for at least 3 seconds to confirm.
SENS - In this mode you can adjust the sound sensitivity.
1. Press the MENU button until “SENS” is displayed, press ENTER. A number between 0-100 will be
displayed.
2. Press the UP or DOWN buttons to adjust the sound sensitivity. 0 being the least sensitive, and 100
being the most sensitive.
3. When you have found your desired setting press ENTER to confirm.
Revo 4 IR System Menu