ADJ Products, LLC - www.adj.com - Quad Scan Pro Instruction Manual Page 12
ADJ Products, LLC - www.adj.com - Quad Scan Pro Instruction Manual Page 13
• BLND (Blackout) - If the DMX signal is lost or power is applied, the
unit will automatically go into stand by mode.
• LAST (Last State) - If the DMX signal is lost the fixture will stay in the
last DMX set up. If power is applied and this mode is set, the unit will
automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
LED -
With this function you can have the LED display
turn off after 10 seconds.
1. Press the MENU button until “LED” is displayed, press ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or
DOWN buttons to select “ON” to keep the LED display on at all
times, or “OFF” to switch to have the LED display switch off after 10
seconds.
3. Press the ENTER button to confirm.
PAN -
Pan Inversion
1. Tap the MENU button until “PAN” is displayed, press ENTER.
Either Yes or No will be displayed.
2. To activate the Pan inversion tap the UP or DOWN buttons until
YES is displayed, press ENTER to confim. To deactivate Pan inver-
sion, select NO and press Enter.
TILT -
Tilt Inversion
1. Tap the MENU button until “TILT” is displayed, press ENTER.
Either YES or NO will be displayed.
2. To activate the Tilt inversion tap the UP or DOWN buttons until
YES is displayed, press ENTER to confim. To deactivate Tilt inver-
sion, select NO and press Enter.
Quad Scan Pro
System Menu
DISP
- This will “flip” the LED display 180º.
1. Press the MENU button until “dISP” is displayed, press ENTER.
2. Either “dISP” or “dSIP” will now be displayed. Press the UP or
DOWN buttons to select one or the other.
3. Press the ENTER button to confirm.
TEST
- This function will run a auto test program.
1. Press the MENU button until “TEST” is displayed, press ENTER.
2. The fixture will now run a auto test.
FHRS
- With this function you can display the running
time of the fixture.
1. Press the MENU button until “FHRS” is displayed, press ENTER.
2. The running time of the fixture will now be displayed. Press MENU
to exit.
VER
- With this function you can display the version soft-
ware of the fixture.
1. Press the MENU button until “VER” is displayed, press ENTER.
2. The software version will now be displayed. Press MENU to exit.
RSET
- Use this function to reset the unit.
1. Press the MENU button until “RSET” is displayed, press ENTER.
2. The fixture will now reset.
Quad Scan Pro
System Menu
