Profile Panel RGBA Trouble Shooting
Listed below are a few common problems the user may encounter,
with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are
wired correctly (pin 3 is “hot”; on some other DMX devices
pin 2 may be ‘hot’). Also, check that all cables are connected
to the right connectors; it does matter which way the inputs
and outputs are connected.
2. Some DMX modes have a dimmer channel. Make sure the dim-
mer channel is not at 0%
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
2. Check the sound sensitivity level. See Sound Active mode.
If problems are not resolved; Contact ADJ® for service.
1-800-322-6337
Profile Panel RGBA Fuse Replacement
With this feature you can connect the fixtures to one another
using the powerCON input and output sockets. The quantity
fixtures that can be connected is 20 @ 120V and 35 @ 240V maxi-
mum. After the maximum connected fixtures you will need to use
a new power outlet.
NOTE: USE CAUTION WHEN POWER LINKING OTHER FIXTURES
TO THE PROFILE PANEL RGBA AS THE POWER CONSUMPTION
OF OTHER LIGHTING FIXTURES WILL VARY!
Disconnect the unit from its power source. Remove the power cord
from the unit. Use a flat head head screwdriver to remove the fuse
holder. Remove the fuse located inside the fuse holder and replace it
with the new fuse. Install the fuse holder and new fuse and secure it.
Profile Panel RGBA Multiple Unit Power Linking
ADJ Products, LLC - www.adj.com - Profile Panel RGBA User Manual Page 25
ADJ Products, LLC - www.adj.com - Profile Panel RGBA User Manual Page 26
16.73”/425mm
9.72”/247mm
3.2”/81.5mm
2.8”/71.5mm
1.18”/30mm
1.14”/29mm
5.88”/149.5mm
8”/203.2mm
Profile Panel RGBA Dimensional Drawing
16.73”/425mm
9.72”/247mm
3.2”/81.5mm
2.8”/71.5mm
1.18”/30mm
1.14”/29mm
5.88”/149.5mm
8”/203.2mm
