ADJ PIN363, Руководство пользователя

Страница: 12 / 16

12
U C I R R E M O T E
The UC IR (sold separately) infrared remote gives you control of various functions, as listed below.
The remote must be aimed towards the front of the fixture, and maximum range is 30 feet.
CONTROLS
• STAND BY - Press this button to blackout the fixture. Press the button again to return to the initial
state. This button is also used to switch between normal mode and energy saving mode. Refer to
the Operating Instructions section of this manual for details.
• FULL ON - Hold this button down to fully illuminate the unit. The unit returns to its previous state
when the button is released.
• STROBE - Press and hold for strobing.
• FADE/GOBO - Press to activate fade mode.
• “” and “DIMMER -” - Use these buttons to adjust the color output intensity when static
color mode is active.
• COLOR - Press to activate static color mode.
• 1-9 - Use buttons 1 & 2 to select the desired fade mode.
• SOUND ON & OFF - These buttons have no defined function for this fixture.
• SHOW 0 - Press this button to activate show mode, and use buttons 1 & 2 to select the desired
fade mode.
A D J L E D R C 3 R E M O T E
The ADJ LED RC3 infrared remote (Sold Separately) has a wide range of functions, giving the user
complete control of this fixture. The controller must be aimed at the front of the fixture, and maximum
range is 30 feet.
CONTROLS
• BLACKOUT - Press to blackout the fixture, or to switch between normal mode and energy saving
mode. The LED will flash 3 times to indicate that the fixture is in normal mode, or flash continu-
ously for 5 seconds to indicate that the fixture is in energy saving mode. Refer to the Operating
Instructions section of this manual for details.
• AUTO RUN MODE - Press the AUTO RUN button to switch between Fast Fade & Slow Fade.
Press the SPEED button and use the + and - buttons to adjust the fade speed. You can press the
FLASH button to activate strobing, then use the + and - buttons to adjust the strobe speed.
• MANUAL MODE - Press the SELECT PROG button to activate WW color. Use the + and - but-
tons to adjust the output intensity. Press the FLASH button to activate strobing, then use the + and
- buttons to adjust the strobe speed.