ADJ Products, LLC - www.adj.com - Par Z4 Instruction Manual Page 16
ADJ Products, LLC - www.adj.com - Par Z4 Instruction Manual Page 17
The ADJ
UC IR (sold separately)
infrared remote gives you control
of various functions
. To control the fixture you must aim the remote
at the front of the fixture and be no more then 30 feet away.
STAND BY
-
Pressing this button will blackout the fixture.
FULL ON
-
Hold this button down to for full intensity. When you let
the button go, the unit will return to its regular intensity.
FADE/GOBO
-
This button is invalid for this fixture.
“” and “DIMMER -” -
Use these buttons to adjust the out-
put intensity.
STROBE
-
This button will activate the strobe effect. Press the but-
ton hold for strobing.
COLOR
-
Press this button to enter color mode. Use the 1-9 buttons
to select your desired color. Adjust the output intensity using the
“” and “DIMMER -” buttons.
1-9
-
In color mode, these buttons will allow you to select a desired
color.
SOUND ON & OFF -
These buttons activate and deactivate the
sound active mode.
SHOW -
This button is invalid for this fixture.
Par Z4
UC IR Operation
Par Z4
Master-Slave Set Up
Master-Slave Operation
This function will allow you to link up to
16 units together and operate without a controller. In a Master-Slave
set up, one unit will act as the controlling unit and the others will react
to the controlling units programs. Any unit can act as a Master or as a
Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit press the MENU button until “
SLND
” is dis-
played, and press ENTER. Use the UP and DOWN buttons to
scroll to the “
MAST
” setting and press ENTER.
3. After setting the Master unit to the master setting find and set
your desired operating mode.
4. On the slave units press the MENU button until “
SLND
” is dis-
played, and press ENTER. Choose either “
SL 1
” or “
SL 2
” and
press ENTER. See page 9 for more info.
5. The slave units will now follow the Master unit.
Par Z4
Zoom Function
To adjust/use the zoom feature, rotate the knob located on the
bottom front of the unit frame. To zoom out or widen the beam rotate
the knob counter-clockwise. To zoom in or narrow the beam rotate
the knob clockwise.
