Fade Time
1. Press and hold down MODE button, and then tap the Tap/disp button, the display
may show you "only"; Repeat this operation when "only" appears, the display will
show you "All".
2. The "only" or "ALL" display will go out automatically within almost 3 seconds.
"ALL" means that All channels run by the fade time.
"Only" means that only the preset PAN/TILT channels run by the fade time.
MIDI Control
1. Press and hold down the Midi button for about 2 seconds, the display may show you
like "In:01", this means the current Midi channel is "01". You can use Up/Down button
to set the Midi channel from 01 to 16 as your desire.
2. Then, press and hold down the Midi button for about 2 seconds to save your setting,
all the LEDs flash briefly indicating your operation has been saved.
Set MIDI channel
3. Press Blackout button to exit.
MIDI Control :
This unit can receive MIDI data to realize MIDI control upon Bank1~15,Chase1~6
and the Blackout function.
Control
Bank 1
Bank 2
Bank 15
Chase 1
Chase 2
Chase 3
Chase 4
Chase 5
Chase 6
Blackout
... ...
MIDI Note
00~07
08~15
112~119
120
121
122
123
124
125
126
... ...
Function
Turn on/off Bank 1
Turn on/off Bank 2
Turn on/off Bank 15
Turn on/off Chase 1
Turn on/off Chase 2
Turn on/off Chase 3
Turn on/off Chase 4
Turn on/off Chase 5
Turn on/off Chase 6
Enable/disable Blackout
... ...
Operation Guide
12
Operation Guide
11
Before turning on the power, press and hold down the Fixture2 button, the Fixture3
button and the Scene1 button; Then turn on the power, the display will flickeringly
show you "Read" (ready). This means the unit is ready to send data.
1.
Data Sending
After the above operation, you press and hold down the Scene7 button and Scene8
button to send the data, the LED-display will show you "OUT" till the data sending is
finished (You can also tap the Scene1 button during data sending to come back and
resend the data).
2.
Before data sending, make sure the connections between this unit and the connected
DMX receiver are well done.
Before turning on the power, press and hold down the Fixture2 button, the Fixture3
button and the Scene2 button; Then turn on the power, the display will flickeringly
show you "Read" (ready). This means the unit is ready to receive data.
1.
Data Receiving
The LED-display shows you "Rece" (receive) during data receiving.
(You can also tap
the Scene1 button during data sending to come back and resend the data).
2.
Before data receiving, make sure the connections between this unit and the connected
DMX receiver are well done.
Memory stick
You can also use a compact memory stick (sold separately) for convenient data backup
and transfer.
Memory stick (sold separately)
