PAN/TILT Setting
"Assign"
1. Enter the Programming mode.
2. Press and hold down the MODE button, and then tap the FINE button at the same
time, the "Assign" LED will be lit.
3. Tap the Up/Down button to select PAN or TILT.
4. Tap your selected Fixture button.
6. You can press and hold down the MODE button, and then tap relevant scene button
to set the Pan/Tilt channel (all LEDs will flash briefly).
"Reverse"
1. Enter the Programming mode.
2. When the "Assign" LED is lit, you press and hold down the MODE button, and then tap
the FINE button at the same time, the "Reverse" LED will be lit.
3. Set the Pan/Tilt channel in the same way as above. After your settings, press and hold
down the MODE button, and then tap the FINE button at the same time to exit.
Delete all Pan/Tilt channels
Before turning on the power, you press and hold down the DEL button and the MODE
button, and then turn on the power at the same time, all LEDs flash briefly, this means
means all Pan/Tilt channels have been deleted.
10
Operation Guide
Delete Pan/Tilt channel
1. When in "Assign" or "Reverse" operating mode, press the related Fixture button.
2. Press and hold down the MODE button, and then tap the DEL button to delete the
Pan/Tilt channel.
Tap the Music/Bkc button, the Audio Trigger LED will light up at the display window,
this indicates you that you are now in the Audio trigger mode.
(1)
Select your desired chase and press related chase button, its LED will flash. The chase
will run sensitively by the audio signal through the built-in microphone.
(2)
3. Audio trigger:
Tap the Audio button again(Audio Trigger LED goes out) to exit from the Audio mode.
(3)
Tap the AUTO button, the Auto Trigger LED will light up at the display window, this
indicates you that you are now in the Auto trigger mode.
(1)
Select your desired chase and press related chase button, its LED will flash.
(2)
You can then use the Speed fader (or Tap/disp button) and the Fade Time fader to
adjust the running state.
(3)
2. Auto trigger:
Tap the Auto button again (Auto Trigger LED goes out) to exit from the Auto mode.
(4)
Note: You can simultaneously run more scenes as your desire, and the enabled scenes
will run by your operating sequence.
9
Operation Guide
Bank copy & Fixture copy
Bank copy
1. Enter the Programming mode.
2. Use the Bank Up/Down buttons to select the bank to be copied.
3. Tap the Midi/Rec button, and then select the bank into which you want to copy.
4. Tap the Music/Bkc button, all LEDs flash briefly, this means your operation has been
saved. (You can copy the other bank in the same way.)
Fixture copy
1. Enter the Programming mode.
2. Press your selected Fixture button, its LED will be lit.
5. You can see the related information through the connected DMX receiver.
3. Set your desired channel output.
4. Press and hold down your selected Fixture button, and then tap the Fixture button into
which you want to copy to finish your Fixture copy.
