ADJ Products, LLC — www.adj.com — Mega QA Go - User Manual — Page
10
3.
Use the UP or DOWN buttons to scroll through the DMX Channel modes. The Channel modes are
listed below:
•
To run the 1 Channel Mode, press the MODE button until “Ch01” is displayed. This is the 1
Channel DMX Mode.
•
To run the 2 Channel Mode, press the MODE button until “Ch02” is displayed. This is the 2
Channel DMX Mode.
•
To run the 3 Channel Mode, press the MODE button until “Ch03” is displayed. This is the 3
Channel DMX Mode.
•
To run the 4 Channel Mode, press the MODE button until “Ch04” is displayed. This is the 4
Channel DMX Mode.
•
To run the 5 Channel Mode, press the MODE button until “Ch05” is displayed. This is the 5
Channel DMX Mode.
•
To run the 6 Channel Mode, press the MODE button until “Ch06” is displayed. This is the 6
Channel DMX Mode.
•
To run the 7 Channel Mode, press the MODE button until “Ch07” is displayed. This is the 7
Channel DMX Mode.
•
To run the 8 Channel Mode, press the MODE button until “Ch08” is displayed. This is the 8
Channel DMX Mode.
4.
Please see pages 20-27 for DMX values and traits.
5.
After you have chosen your desired DMX Channel mode plug in the fixture via the XLR connections
to any standard DMX controller.
RGBA Dimmer Mode:
1.
Plug the fixture in and press the MODE button until:
2.
When “r.XXX” is displayed you are in Red dimming mode. Press the UP and DOWN buttons to
adjust intensity.
3.
When “G.XXX” is displayed you are in Green dimming mode. Press the UP and DOWN buttons to
adjust intensity.
4.
When “b.XXX” is displayed you are in Blue dimming mode. Press the UP and DOWN buttons to
adjust intensity.
5.
When “A.XXX” is displayed you are in Amber dimming mode. Press the UP and DOWN buttons to
adjust intensity.
6.
After you have adjusted the RGBA colors to make your desired color you can then activate strobing
by pressing the SET UP but- ton to enter the Flash (strobe) mode.
7.
“FS.XX” will be displayed, this is Flash mode. The Flash can be adjusted between “FS.00” (flash
off) to “FS.15” (fastest flash).
Sound Active Mode:
1.
Plug the fixture in and press the MODE button until “SoXX” is dis- played. “XX” represents the
current sound active mode (1-16).
2.
Use the UP or DOWN buttons to find your desired sound active mode.
3.
Press the SET UP button to enter sound sensitivity adjustment. “SJ-X” will be displayed. Use the
UP or DOWN buttons to adjust the sensitivity. “SJ-1” is the lowest sensitivity, “SJ-8” is the highest.
Mega QA Go
Operating Instructions
