11
Encore Profile Pro WW
Installation
Always ensure that the unit is firmly fixed to avoid vibration and slipping while operating. Always ensure that the
structure to which you are attaching the unit is secure and is able to support a weight of 10 times the unit’s
weight.
Always
use safety cables that can hold 12 times the weight of the unit when installing the fixture. This
equipment must be installed by a professional, and it must be installed in a place where it is out of the reach of
people’s grasp.
The Encore Profile Pro WW is fully operational in three different mounting positions; hanging upside-down,
mounted sideways on trussing, or set on a flat level surface. Be sure this fixture is kept at least 12m (40ft) away
from any flammable materials (decoration etc.).
OVERHEAD RIGGING:
The Encore Profile Pro WW includes two rigging options.
1) OMEGA BRACKET -
Mount the fixture with an appropriately rated professional grade rigging clamp (not
included) to the included Omega Bracket using an M12 screw and nut (not included). With the rigging clamp
securely attached to the Omega Bracket, attach the Omega Bracket to the fixture by inserting both of the 1/4-turn
quick-lock fasteners into the aligning holes on the fixture yoke bracket, and turning each clockwise to secure.
MAKE SURE THE OMEGA BRACKET IS SECURELY ATTACHED BEFORE RIGGING FIXTURE!
2) MOUNTING YOKE -
Mount the fixture with an appropriately rated professional grade rigging clamp (not
included) to the fixture yoke bracket center hole using an M12 screw and nut (not included).
MAKE SURE THE
CLAMP IS SECURELY ATTACHED BEFORE RIGGING FIXTURE!
SAFETY CABLE:
Pull the safety-cable through the opening located on the rear of the unit and over the trussing
system or a safe fixation spot. Insert the end in the carabiner and tighten the safety screw.
Always
use and install
a safety cable as a safety measure to prevent accidental damage and/or injury in the event the clamp fails.
CLAMP INSTALLATION
When mounting fixture to truss, be sure to secure an appropriately rated professional grade rigging clamp to
either the included
Omega Brackets
using an M10 screw fitted through the center hole of the
Omega Brackets
,
or to the
Mounting Yoke
. The fixture provides a built-in rigging point for a
SAFETY CABLE
(not included). Be
sure to only use one of the designated rigging point for the safety cable and never secure a safety cable to the
carrying handle.
Safety Cable
(Not included)
A Truss Clamp can be
mounted directly to yoke
Mounting Holes for Omega
Bracket Installation
S A F E T Y C A B L E
ALWAYS ATTACH A SAFETY WHENEVER INSTALLING THIS FIXTURE IN A SUSPENDED
ENVIRONMENT TO ENSURE THE FIXTURE WILL NOT FALL IF THE CLAMP FAILS.
It’s not enough
that the Safety Cable is attached to the fixture, it must also be routed around the truss or secure
fixation point and both ends securely affixed to the carabiner attached at the built-in rigging point.
Encore Profile Pro WW
Installation
